Nissan Rogue (T33) 2021-Present Service Manual: Symptom Diagnosis :: Engine Does Not Start When Intelligent Key Is Inside of Vehicle

Nissan Rogue (T33) 2021-Present Service Manual / Body Exterior, Doors, Roof & Vehicle Security :: Security Control System / Symptom Diagnosis :: Engine Does Not Start When Intelligent Key Is Inside of Vehicle

Description

Engine does not start when push-button ignition switch is pressed while carrying Intelligent Key.

NOTE:

  • Before starting diagnosis check that Nissan Ariya vehicle condition is as shown in “Conditions of vehicleâ€�, and check each symptom.

  • The engine start function, door lock function, power distribution system, and NATS-IVIS/NVIS in the Intelligent Key system are closely related to each other regarding control. The Nissan Ariya vehicle security function can operate only when the door lock and power distribution system are operating normally.

SYMPTOM TABLE (BOTH INTELLIGENT KEYS HAVE THE SAME SYMPTOMS)

Door lock operation (remote keyless entry) Door lock operation (request switch of front/rear/back door) or trunk/back door open operation (opener switch of trunk/back door panel) Engine started with push-button ignition switch operation (registered Intelligent Key is within the detection area of inside key antenna) Engine started with push-button ignition switch operation (registered Intelligent Key placed next to push-button ignition switch) Unlock operation when approaching the Nissan Ariya vehicle, lock operation when away from the vehicle (registered Intelligent Key is within the detection area of outside key antenna)
OK OK No crank, No start OK OK

CONDITIONS OF VEHICLE (OPERATING CONDITIONS)

  • “ENGINE START BY I-KEYâ€� setting in “WORK SUPPORTâ€� mode of “HANDS FREE MODULEâ€� is ON.

  • One or more Intelligent Keys with a registered Intelligent Key ID are in the Nissan Ariya vehicle.

DIAGNOSIS PROCEDURE

Refer to Diagnosis Procedure.

Diagnosis Procedure

CHECK INTELLIGENT KEY SYSTEM SYMPTOM TABLE

Check Intelligent Key system symptom table. Refer to Diagnosis Procedure

>>

GO TO 2.

PERFORM SELF DIAGNOSIS RESULT

CONSULT

Select “Self diagnosis result� mode of “INTELLIGENT KEY�, and check if DTC is detected.

Is DTC detected?

YES>>

Perform the trouble diagnosis for the detected DTC.

NO>>

GO TO 3.

CHECK INSIDE KEY ANTENNA

Use SIGNAL TECH II to check each inside key antenna. For the inspection method and how to use SIGNAL TECH II, refer to “NISSAN/INFINITI SIGNAL TECH II USER GUIDE�.

Is the inspection result normal?

YES>>

GO TO 5.

NO>>

Repair or replace malfunctioning parts.

CHECK PUSH-BUTTON IGNITION SWITCH

Check push-button ignition switch. Refer to Component Function Check.

Is the inspection result normal?

YES>>

GO TO 6.

NO>>

Repair or replace malfunctioning parts.

REPLACE INTELLIGENT KEY UNIT

  1. Replace Intelligent Key unit. Refer to Removal and Installation.

  2. Check operation after replacement.

Is the inspection result normal?

YES>>

Inspection End.

NO>>

Check intermittent incident. Refer to Intermittent Incident.

    Symptom Diagnosis. Engine Can Not Start
    Description Engine does not start when push-button ignition switch is pressed.SYMPTOM TABLE (BOTH INTELLIGENT KEYS HAVE THE SAME SYMPTOMS) Door lock operation (remote keyless en...
    Symptom Diagnosis. Engine Does Not Start When Intelligent Key Is Inside of Vehicle (one Key)
    Description Engine does not start when push-button ignition switch is pressed. (One Intelligent Key has the symptom, other keys operate normally.)SYMPTOM TABLE (ONE INTELLIGENT ...

    Other materials:

    With Idle Start/stop. Removal and Installation. Sub Starter & Generator
    Sub Starter & Generator Exploded View REMOVAL 1. Collar 2. Sub starter, generator and compressor bracket 3. Sub starter & generator 4. Sub starter & generator harness connector 5. “B� terminal - - : Nissan Ariya Vehicle front , , , : In ...

    Ecu Diagnosis Information. Passenger Door Mirror Control Module
    Reference Value TERMINAL LAYOUTPHYSICAL VALUES Terminal No. (Wire color) Description Condition Value (Approx.) (+) (−) Signal name Input/Output 1 (BR) Ground Door mirror sensor (passenger side) left/right signal Input Door mirror RH position Change between 6 V ( ...

    Service Data and Specifications (sds)
    Wheel Alignment JAPAN PRODUCTION MODELS Item Standard Camber Degree minute (Decimal degree) Minimum –1° 20′ (–1.33°) Nominal –0° 35′ (–0.58°) Maximum 0° 10′ (0.17°) Toe-in Total toe-in Distance Minimum In 0.5 mm (In 0.02 in) Nomin ...