Nissan Rogue Service Manual: Symptom diagnosis
THE SPORT MODE INDICATOR LAMP DOES NOT TURN ON
Description
The SPORT mode indicator lamp does not turn ON when the SPORT mode switch is operated.
Diagnosis Procedure
1.CHECK SPORT MODE INDICATOR LAMP FUNCTION
Perform combination meter self-diagnosis mode and check test order 10. Refer to MWI-19, "Description".
Is the check result normal? YES >> GO TO 2.
NO >> Replace combination meter. Refer to MWI-82, "Removal and Installation".
2.CHECK DTC (TCM)
With CONSULT
- Start the engine.
- Check “Self Diagnostic Results” in “TRANSMISSION”.
Is any DTC detected? YES >> Check DTC detected item. Refer to TM-63, "DTC Index".
NO >> GO TO 3.
3.CHECK DTC (ECM)
With CONSULT
Check “Self Diagnostic Results” in “ENGINE”.
Is any DTC detected? YES >> Check DTC detected item. Refer to EC-93, "DTC Index".
NO >> GO TO 4.
4.CHECK DTC (COMBINATION METER)
With CONSULT
Check “Self Diagnostic Results” in “METER/M&A”.
Is any DTC detected? YES >> Check DTC detected item. Refer to MWI-30, "DTC Index".
NO >> GO TO 5.
5.CHECK COMBINATION METER INPUT/OUTPUT SIGNAL
With CONSULT
- Select “Data Monitor” in “METER/M&A”.
- Select “SPORT MODE IND”.
- Check that “SPORT MODE IND” turns ON/OFF when SPORT mode switch is operated. Refer to MWI-24, "Reference Value".
Is any DTC detected? YES >> Replace combination meter. Refer to MWI-82, "Removal and Installation".
NO >> GO TO 6.
6.CHECK SPORT MODE SWITCH CIRCUIT
Check SPORT mode switch circuit. Refer to DMS-13, "Diagnosis Procedure".
Is any DTC detected? YES >> INSPECTION END
NO >> Repair or replace malfunctioning parts.
DTC/circuit diagnosis
SPORT MODE SWITCH
Component Function Check
1. CHECK SPORT MODE SWITCH OPERATION
Turn ignition switch ON.
Check SPORT mode indicator lamp turns ON/OFF on combination meter
when t ...
Removal and installation
SPORT MODE SWITCH
Removal and Installation
REMOVAL
Remove instrument lower panel LH. Refer to IP-14, "Exploded View".
Remove SPORT mode switch.
INSTALLATION
Installat ...
Other materials:
Sample/Wiring Diagram -Example-
Each section includes wiring diagrams.
Description
Number
Item
Description
1
Power supply
This means the power supply of fusible link or fuse.
2
Fuse
“/” means the fuse.
3
Current rating of fusible
...
P0138 HO2S2
DTC Description
DTC DETECTION LOGIC
The heated oxygen sensor 2 has a much longer switching time between rich and
lean than the air fuel ratio (A/
F) sensor 1. The oxygen storage capacity of the three way catalyst (manifold)
causes the longer switching
time.
MALFUNCTION A
To judge the malfu ...
Map lights
Map lights
Push the button to turn the map lights on. To turn
them off, press the button again.
CAUTIONDo not use for extended periods of time
with the engine stopped. This could result
in a discharged battery.
Personal Lights (if so equipped)
Rear personal lights
To tu ...
