Nissan Rogue (T33) 2021-Present Service Manual: Sonar Branch Line Circuit (its Can Communication 4 Circuit)

Nissan Rogue (T33) 2021-Present Service Manual / Electrical & Power Control :: Lan System / Can :: Dtc/circuit Diagnosis / Sonar Branch Line Circuit (its Can Communication 4 Circuit)

Diagnosis Procedure

CHECK CONNECTOR

  1. Turn the ignition switch OFF.

  2. Disconnect the battery cable from the negative terminal.

  3. Check the terminals and connectors of the sonar control unit for damage, bend and loose connection (unit side and connector side).

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair the terminal and connector.

CHECK HARNESS FOR OPEN CIRCUIT

  1. Disconnect the connector of sonar control unit.

  2. Check the resistance between the sonar control unit harness connector terminals.

    Sonar control unit harness connector Resistance (Ω)
    Connector No. Terminal No.
    B20 5 6 Approx. 54 – 66

Is the measurement value within the specification?

YES>>

GO TO 3.

NO>>

Repair the sonar control unit branch line.

CHECK POWER SUPPLY AND GROUND CIRCUIT

Check the power supply and the ground circuit of the sonar control unit. Refer to Diagnosis Procedure.

Is the inspection result normal?

YES (Present error)>>

Replace the sonar control unit. Refer to Removal and Installation.

YES (Past error)>>

Error was detected in the sonar control unit branch line.

NO>>

Repair the power supply and the ground circuit.

    Avm Branch Line Circuit (its Can Communication 4 Circuit)
    Diagnosis Procedure CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the around view ...
    Icc 2 Branch Line Circuit (its Can Communication 4 Circuit)
    Diagnosis Procedure CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the ADAS control...

    Other materials:

    P02ee Fuel Injector
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P02EE 00 Cylinder 1 injector (Cylinder 1 Injector Circuit Range/Performance) Diagnosis condition Injector compensation control is operating Signal — ...

    P2135 Tp Sensor
    DTC Description DTC DETECTION LOGICNOTE: If DTC P2135 is displayed with DTC P06B0, first perform the trouble diagnosis for DTC P06B0. Refer to DTC Description. DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P2135 00 TP SENSOR-B1 (Throttle/Pedal ...

    Symptom Diagnosis. Easy Fill Tire Alert Does Not Activate
    Description The easy fill tire alert does not function while inflating a tire when the CVT shift selector position is in P-range with the ignition switch ON or with the engine started.NOTE: After starting to inflate the tire, it takes a few seconds for the easy fill tire alert to function. ...