Nissan Rogue (T33) 2021-Present Service Manual: Removal and Installation :: Rear Side Air Bag Module
Exploded View
Rear side air bag module is built in to seatback bolster.
For exploded view of seatback bolster. Refer to Exploded View.
Removal and Installation
CAUTION:
Removal of a single part is not possible. For removal, remove seatback bolster as a set.
For removal and installation of seatback bolster. Refer to Removal and Installation.
Other materials:
Heated Oxygen Sensor 2
Component Function Check
PERFORM COMPONENT FUNCTION CHECK-1
Without CONSULT
Start engine and warm it up to normal operating temperature.
Turn ignition switch OFF and wait at least 10 seconds.
Start engine and keep the engine speed between 3,500 and 4,000 rpm for at least 1 minute u ...
Basic Inspection. Tire Pressure Sensor Id Registration
Description
This procedure must be performed.
After replacement of a tire pressure sensor or BCM.
After replacement of tire or road wheel.
NOTE:
ID registration is unnecessary if there are no change in
the positions of each wheels (tire pressure sensors) before wheel
removal and after ...
P2a01 Ho2s2
DTC Description
The heated oxygen sensor 2 has a much longer switching time between
rich and lean than the air fuel ratio (A/F) sensor 1. The oxygen storage
capacity of the three way catalyst (manifold) causes the longer
switching time.MALFUNCTION ATo judge the malfunctions of
heated oxygen ...