Nissan Rogue manuals

Nissan Rogue Owners Manual: RearView Monitor (if so equipped)

When the shift lever is shifted into the R (Reverse) position, the monitor display shows the view to the rear of the vehicle.

WARNING

Failure to follow the warnings and instructions for proper use of the RearView Monitor could result in serious injury or death.

  •  The RearView Monitor is a convenience but it is not a substitute for proper backing.

    Always turn and look out the windows, and check mirrors to be sure that it is safe to move before operating the vehicle. Always back up slowly.

  •  The system is designed as an aid to the driver in showing large stationary objects directly behind the vehicle, to help avoid damaging the vehicle.
  •  The system cannot completely eliminate blind spots and may not show every object.
  •  Underneath the bumper and the corner areas of the bumper cannot be viewed on the RearView Monitor because of its monitoring range limitation. The system will not show small objects below the bumper, and may not show objects close to the bumper or on the ground.
  •  Objects viewed in the RearView Monitor differ from actual distance because a wide-angle lens is used.
  •  Objects in a RearView Monitor will appear visually opposite than when viewed in the rear view and outside mirrors.
  •  Make sure that the trunk is securely closed when backing up.
  •  Do not put anything on the rearview camera. The rearview camera is installed above the license plate.
  •  When washing the vehicle with high pressure water, be sure not to spray it around the camera. Otherwise, water may enter the camera unit causing water condensation on the lens, a malfunction, fire or an electric shock.
  •  Do not strike the camera. It is a precision instrument. Otherwise, it may malfunction or cause damage resulting in a fire or an electric shock.

 

CAUTION

There is a plastic cover over the camera.

Do not scratch the cover when cleaning dirt or snow from the cover.

How to use the [ ] button
For additional information, refer to the separate Navigation System Owner’s Manual regarding the “SiriusXM® Travel Link”, and “Traffic” features. For additional information, refer ...

How to read the displayed lines
Guiding lines which indicate the vehicle width and distances to objects with reference to the vehicle body line A are displayed on the monitor. Distance guide lines: Indicate distances from th ...

Other materials:

DTC/circuit diagnosis
U1000 CAN COMM CIRCUIT Description Refer to LAN-8, "System Description". DTC Logic DTC DETECTION LOGIC NOTE: U1000 can be set if a module harness was disconnected and reconnected, perhaps during a repair. Confirm that there are actual CAN diagnostic symptoms and a present DTC by p ...

System
WARNING CHIME SYSTEM WARNING CHIME SYSTEM : System Description SYSTEM DIAGRAM (WITH INTELLIGENT KEY SYSTEM) SYSTEM DIAGRAM (WITHOUT INTELLIGENT KEY SYSTEM) COMBINATION METER INPUT/OUTPUT SIGNAL (CAN COMMUNICATION SIGNAL) Input signal Output signal BCM INPUT/OUTPUT SIGNAL (CAN ...

Removal and installation
POWER SOCKET Removal and Installation FRONT POWER SOCKET Removal  Remove cluster lid C. Refer to IP-21, "Removal and Installation".  Release the pawls on the power socket and remove from the cluster lid C. Installation Installation is in the reverse order of remov ...

© 2014-2023 Copyright www.nirogue.com