Nissan Rogue (T33) 2021-Present Service Manual: Rdr-Rr Branch Line Circuit

Nissan Rogue (T33) 2021-Present Service Manual / Electrical & Power Control :: Lan System / Can :: Dtc/circuit Diagnosis / Rdr-Rr Branch Line Circuit

Diagnosis Procedure

CHECK CONNECTOR

  1. Turn the ignition switch OFF.

  2. Disconnect the battery cable from the negative terminal.

  3. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side).

    • Side radar rear RH

    • Harness connector B456

    • Harness connector B79

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair the terminal and connector.

CHECK RIGHT/LEFT SWITCHING SIGNAL CIRCUIT

Check the right/left switching signal circuit of the side radar rear RH. Refer to Diagnosis Procedure.

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair the root cause.

CHECK HARNESS FOR OPEN CIRCUIT

  1. Disconnect the connector of side radar rear RH.

  2. Check the resistance between the side radar rear RH harness connector terminals.

    • Without ProPILOT Assist 2.1

      Side radar rear RH harness connector Resistance (Ω)
      Connector No. Terminal No.
      B462 1 2 Approx. 108 – 132
      8 7 Approx. 108 – 132

    • With ProPILOT Assist 2.1

      Side radar rear RH harness connector Resistance (Ω)
      Connector No. Terminal No.
      B468 1 2 Approx. 108 – 132
      8 7 Approx. 108 – 132

Is the measurement value within the specification?

YES>>

GO TO 4.

NO>>

Repair the side radar rear RH branch line.

CHECK POWER SUPPLY AND GROUND CIRCUIT

Check the power supply and the ground circuit of the side radar rear RH. Refer to Diagnosis Procedure.

Is the inspection result normal?

YES (Present error)>>

Replace the side radar rear RH. Refer to Removal and Installation.

YES (Past error)>>

Error was detected in the side radar rear RH branch line.

NO>>

Repair the power supply and the ground circuit.

    Laser Branch Line Circuit
    Diagnosis Procedure CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the following terminals and connectors for damag...
    Eps/dast 3 Branch Line Circuit (chasssis Can Communication 1 Circuit)
    Diagnosis Procedure CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the following terminals and connectors for damag...

    Other materials:

    Steering Assist
    Basic information Steering Assist is a part of the ProPILOT Assist Systems available on the Nissan Rogue. Read the entire ProPILOT Assist section before using this system, including how to operate it and how to understand the display information. Steering Assist uses a forward-facing camera to detec ...

    With Idle Start/stop. System Description
    Component Parts Component Parts Location No. Component Function 1. Sub starter & generator Refer to Sub starter & generator. 2. Battery current sensor (with battery temperature sensor) Refer to 12V Battery Current Sensor . 3. ECM (Engine Control Module The ...

    C10af-01 Pressure Sensor
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition C10AF 01 Pressure sensor (Pressure sensor) Diagnosis condition During driving below 15 km/h (9.4 MPH) (no braking) When the power supply voltage is nor ...