Nissan Rogue (T33) 2021-Present Service Manual: Preparation

Nissan Rogue (T33) 2021-Present Service Manual / Body Exterior, Doors, Roof & Vehicle Security :: Exterior / Preparation

Special Service Tools

The actual shapes of TechMate tools may differ from those of special service tools illustrated here.

Tool number

(TechMate No.)

Tool name 		  Description

(NI-39570)

Chassis ear

Locates the noise

(NI-50397)

Squeak and Rattle Kit

Repairs the cause of noise

CommercialServiceTools

Tool name Description
Engine ear

Locates the noise
Power tool

Loosening bolts, nuts and screws

Always Replace with New Parts

Always Replace with New Parts
Do not Reuse These PartsPart CodeFor additional information:
Cowl top cover seal - COWL TOP EXPLODED VIEW
EPT seal - COWL TOP EXPLODED VIEW
RH front door sash tape 80816N DOOR SASH COVER EXPLODED VIEW
RH front door sash tape 80816NA DOOR SASH MOLDING EXPLODED VIEW
LH front door sash tape 80817N DOOR SASH COVER EXPLODED VIEW
LH front door sash tape 80817NA DOOR SASH MOLDING EXPLODED VIEW
RH rear door sash tape 82816X DOOR SASH MOLDING EXPLODED VIEW
RH rear door sash tape 82816XA DOOR SASH COVER EXPLODED VIEW
RH rear door sash tape 82816XB DOOR SASH COVER EXPLODED VIEW
LH rear door sash tape 82817X DOOR SASH MOLDING EXPLODED VIEW
LH rear door sash tape 82817XA DOOR SASH COVER EXPLODED VIEW
LH rear door sash tape 822817XB DOOR SASH COVER EXPLODED VIEW
Front door moulding tape - DOOR SASH MOLDING EXPLODED VIEW
Rear door moulding tape - SIDE GUARD MOLDING EXPLODED VIEW
Clip 85012F REAR BUMPER EXPLODED VIEW
Grommet 76018G FRONT PILLAR FINISHER EXPLODED VIEW
Clip - FRONT PILLAR FINISHER EXPLODED VIEW
Rubber - FRONT PILLAR FINISHER EXPLODED VIEW
Rivet 73019E ROOF RAIL EXPLODED VIEW
Rivet 73017E ROOF SIDE MOLDING EXPLODED VIEW
Double sided tape - PARTING SEAL EXPLODED VIEW
Emblem-Back Door 84890M EMBLEM EXPLODED VIEW
Emblem-Back Door 84815M EMBLEM EXPLODED VIEW
Emblem-Back Door 90890+B EMBLEM EXPLODED VIEW
Emblem-Back Door 90890+A EMBLEM EXPLODED VIEW
Emblem-Back Door 84815MA EMBLEM EXPLODED VIEW
Emblem-Back Door 84815MB EMBLEM EXPLODED VIEW
Emblem-Front Door RH 62892 EMBLEM EXPLODED VIEW
Emblem-Front Door LH 62892+A EMBLEM EXPLODED VIEW
    Precaution. Precautions
    PRECAUTIONS FOR SUPPLEMENTAL RESTRAINT SYSTEM (SRS) AIR BAG AND SEAT BELT PRE-TENSIONER : Precautions The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PR...
    System Description. Component Parts. Active Grille Shutter System
    Active Grille Shutter System Component Parts Location No. Component Function IPDM E/R Refer to Component Parts Location for detailed component location. ECM Refer to ECM for det...

    Other materials:

    Symptom Diagnosis. Heated Steering Wheel System Does Not Activate
    Description The heated steering wheel does not warm up. The heated steering wheel system cannot be turned OFF. Diagnosis Procedure PERFORM SELF DIAGNOSTIC RESULT CONSULT Ignition switch ON. Select “Self Diagnostic Result” mode of “HVAC”. Check DTC. Is DT ...

    B20dd-73 Ign Relay on Circ
    DTC Description IPDM E/R operates the ignition relay when it receives an ignition ON signal from BCM via CAN communication. Turn the ignition relay OFF by pressing the push-button ignition switch once when the Nissan Ariya vehicle speed is 2.5 MPH (4 km/h) or less. Turn the igniti ...

    Evap Control System Pressure Sensor
    Component Inspection CHECK EVAP CONTROL SYSTEM PRESSURE SENSOR Turn ignition switch OFF. Remove EVAP control system pressure sensor with its harness connector connected from EVAP canister. Always replace O-ring with a new one. Install a vacuum pump to EVAP control system pressure se ...