Nissan Rogue (T33) 2021-Present Service Manual: Paddle Shifter

Removal and Installation

REMOVAL

For servicing the Japan production paddle shifter, service the Japan production steering wheel. Refer to Removal and Installation.

NOTE:

The Japan production paddle shifter is serviced as an assembly with the Japan production ASCD steering switch (if so equipped), the Japan production ProPILOT Assist 1.1 steering switch (if so equipped), the Japan production ProPILOT Assist 2.1 steering switch (if so equipped), the Japan production steering switches, and the Japan production steering wheel.

For servicing the USA production paddle shifter, continue with this procedure.

NOTE:

The USA production shift up switch and the USA production shift down switch are serviced as the USA production paddle shifter kit.

Remove the steering switches and the ASCD steering switch (if so equipped) or the ProPILOT Assist 1.1 steering switch (if so equipped). Refer to Removal and Installation.

NOTE:

The USA production steering switches are serviced as a kit with the ASCD steering switch (if so equipped) or the ProPILOT Assist 1.1 steering switch (if so equipped).

Remove the steering wheel. Refer to Removal and Installation.

Remove the screws from the harnesses on the steering wheel.

Disconnect the harness connectors from the steering wheel.

Remove the screws from the steering wheel upper finisher.

Using a suitable tool, release the pawls and the steering wheel upper finisher.

Remove the screws from the steering wheel rear finisher.

Using a suitable tool, release the pawls and partially remove the steering wheel rear finisher. Reposition the steering wheel rear finisher to access the harness connectors on the paddle shifter.

Disconnect the harness connectors from the paddle shifter.

Remove the screws and the paddle shifter from the steering wheel.

INSTALLATION

Installation is in the reverse order of removal.