Nissan Rogue (T33) 2021-Present Service Manual: P1a10 Ecm Initial Learning Incomplete

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / P1a10 Ecm Initial Learning Incomplete

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
P1A10 00

ECM initial learning Incomplete

(ECM initial learning Incomplete) 		Diagnosis condition Ignition switch ON
Signal (terminal) —
Threshold When drive distance will be less than 96 km (60 miles) and ECM keeps initial state to replace ECM will indicate DTC.
Diagnosis delay time —

POSSIBLE CAUSE

ECM initial learning not complete

FAIL-SAFE

Not applicable

DTC Confirmation Procedure

PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

TESTING CONDITION:

  • Before performing the following procedure, confirm that battery voltage is more than 11 V at idle.

>>

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE

With CONSULT

  1. Turn ignition switch ON.

  2. Check 1st trip DTC.

Is 1st trip DTC detected?

YES>>

Proceed to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

PERFORM ECM INITIAL LEARNING

  1. Turn ignition switch ON. (Do not start the engine.)

  2. Set selector lever to P position and apply parking brake.

  3. Accelerator pedal is fully depressed and erase DTC.

  4. Turn ignition switch OFF.

  5. Check that no DTC is detected.

>>

INSPECTION END

    P1805 Brake Switch
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P1805 00 BRAKE SW/CIRCUIT (Brake switch/circuit) Diagnosis condi...
    P2096 A/f Sensor 1
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P2096 00 POST CATALYST FUEL TRIM SYS B1 (Post catalyst fuel trim...

    Other materials:

    Can Gateway. Removal and Installation. 8ch Can Gateway
    8ch Can Gateway Removal and Installation NOTE: Perform ADDITIONAL SERVICE WHEN REPLACING 8CH CAN GATEWAY. Refer to Work Procedure. REMOVALRemove combination meter. Refer to the following. Full TFT meter: Removal and Installation 7 inch information display: Removal and Installation ...

    Dlc Branch Line Circuit
    Diagnosis Procedure CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the following terminals and connectors for damage, bend and loose connection (connector side and harness side). Data link connector 8CH CAN gatew ...

    Symptom Diagnosis. Low Tire Pressure Warning Lamp Does Not Turn Off
    Description The low tire pressure warning lamp does not turn OFF after several seconds is passed after engine starts. Diagnosis Procedure CHECK TIRE PRESSURE Ignition switch ON. CAUTION: Never start the engine. Check the tire pressure for all wheels and adjust to the specified value ...