Nissan Rogue (T33) 2021-Present Service Manual: P1805 Brake Switch
DTC Description
DTC DETECTION LOGIC
| DTC |
CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition | ||
| P1805 | 00 |
BRAKE SW/CIRCUIT (Brake switch/circuit) |
Diagnosis condition | — |
| Signal (terminal) | CAN communication signal | |||
| Threshold | A stop lamp switch signal is not sent to ECM while the Nissan Ariya vehicle is driving | |||
| Diagnosis delay time | — | |||
POSSIBLE CAUSE
Stop lamp switch (BCM)
FAIL-SAFE
Engine Control System
Not applicable
Stop/Start System
When a DTC is detected, the stop/start indicator lamp blinks slowly and the stop/start system operation is prohibited.
When ECM detects error while operating the stop/start system, ECM restarts the engine.
DTC Confirmation Procedure
PERFORM DTC CONFIRMATION PROCEDURE
-
Turn ignition switch ON.
-
Fully depress the brake pedal for at least 5 seconds.
-
Erase the DTC.
-
Check 1st trip DTC.
Is 1st trip DTC detected?
YES>>Proceed to DTC Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
DTC Diagnosis Procedure
PERFORM BCM DIAGNOSIS
Perform BCM diagnosis. Refer to DTC Index.
Is the inspection result normal?
YES>>INSPECTION END
NO>>Repair or replace error-detected parts.
Other materials:
Intelligent Key
CONSULT Function (BCM - INTELLIGENT KEY)
DATA MONITORNOTE:
The following table includes information (items)
inapplicable to this Nissan Ariya vehicle. For information (items)
applicable to this vehicle, refer to CONSULT display items.
Monitor Item Condition
Stop/start switch
[On/Off]
...
P1536 Ascd System
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P1536
00
Cruise control
(Cruise control)
Diagnosis condition
Ignition switch ON
Signal
CAN communication signal
Threshold
ECM cannot receive a ...
Service After Replacing or Removing Engine Parts
Description
X: Applicable Part name Service performed Required service Reference
Replacement Removal
ECM
X
—
Additional service when replacing ECM
Work Procedure
Fuel injector offset learning
Work Procedure
Turbocharger wastegate control solenoid valve d ...
