Nissan Rogue (T33) 2021-Present Service Manual: Additional Service When Replacing Around View Monitor Control Unit

Nissan Rogue (T33) 2021-Present Service Manual / Driver Information & Multimedia :: Audio, Visual & Navigation System / Intelligent Around View Monitor :: Basic Inspection / Additional Service When Replacing Around View Monitor Control Unit

Description

CAUTION:

  • When replacing the around view monitor control unit, always replace it with a new one. Intelligent around view monitor system does not operate properly in case of reuse of the around view monitor control unit from another Nissan Ariya vehicle.

  • When before writing the around view monitor control unit configuration, always writing the MAC key.

Perform the following operations when replacing around view monitor control unit. For details, refer to Work Procedure.

AFTER REPLACEMENT

When after replacing around view monitor control unit, the following items must be performed. Or not doing so, intelligent around view monitor system does not operate normally.

  • Writing MAC key

  • Configuration

  • Camera calibration

Work Procedure

Perform the following procedures after replacing the around view monitor control unit.

REPLACE AROUND VIEW MONITOR CONTROL UNIT

Replace around view monitor control unit. Refer to Removal and Installation.

>>

GO TO 2.

WRITING MAC KEY

Perform MAC key writing. Refer to Description.

>>

GO TO 3.

PERFORM CONFIGURATION

CAUTION:

When before writing the around view monitor control unit configuration, always writing the MAC key.

Perform "Replace ECU".

>>

GO TO 4.

WRITING OF CALIBRATION DATA

Write the calibration data stored in the camera using CONSULT. Refer to Work Procedure.

>>

GO TO 5.

PERFORM SELF-DIAGNOSIS

  1. Perform the self-diagnosis of around view monitor control unit with CONSULT (AVM).

  2. Check if any DTC is detected.

Is any DTC detected?

YES>>

Perform the trouble diagnosis for the detected DTC. Refer to DTC Index.

NO>>

GO TO 6.

OPERATION CHECK

Confirm that the operation of the intelligent around view monitor and the camera image (reference line, expected route) are normal.

>>

WORK END

    Diagnosis and Repair Workflow
    Intelligent Around View Monitor Work Flow OVERALL SEQUENCE Reference 1··· Refer to Consult Function. Reference 2··· Refer to DTC Index. Reference 3··· Refer to Symptom ...
    Parameter Writing
    Work Procedure DescriptionWhen replace each camera, it is necessary to write the camera parameters using CONSULT.Write to around view monitor control unit according to "Paramete...

    Other materials:

    Awd. Service Data and Specifications (sds). Service Data and Specifications (sds)
    Service Data and Specifications (sds) Wheel Bearing Axial end play 0.05 mm (0.002 in) or less Drive Shaft Item   Standard Grease quantity Wheel side 49 – 69 g (1.73 – 2.43 oz) Final drive side 78 – 98 g (2.76 – 3.45 oz) Boots installed length* Wheel ...

    Dtc/circuit Diagnosis. Memory Indicator
    Component Function Check CHECK FUNCTION Push set switch. Check memory indicator operation. When driver seat position is already retained in memory : Illuminated for 5 seconds When driver seat position is not retained in memory : Illuminated for 0.5 second Is the ins ...

    Vehicle information display warnings and indicators
    Engine start operation indicator This indicator appears when the shift position is set to P (Park). It informs the driver that the engine will start when the ignition switch is pushed while depressing the brake pedal. The Nissan Rogue engine can be started directly in any ignition switch position. ...