Nissan Rogue (T33) 2021-Present Service Manual: P1574 Ascd Vehicle Speed Sensor

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / P1574 Ascd Vehicle Speed Sensor

DTC Description

DESCRIPTION

The ECM receives two vehicle speed sensor signals via CAN communication line. One is sent from VDC (Nissan Ariya vehicle dynamics control), and the other is from TCM (Transmission control module). The ECM uses these signals for ASCD control. Refer to System Description.

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
P1574 00

ASCD VHL SPD SEN

(ASCD VHL SPD SEN) 		Diagnosis condition Nissan Ariya Vehicle speed: More than 40 km/h (25 MPH)
Signal (terminal) —
Threshold ASCD Nissan Ariya vehicle speed signals are out of the specified range
Diagnosis delay time —

POSSIBLE CAUSE

  • Harness or connectors (CAN communication line is open or shorted.)

  • ABS actuator and electric unit (control unit)

  • TCM

  • ECM

FAIL-SAFE

Not applicable

DTC Confirmation Procedure

CHECK DTC PRIORITY

If DTC P1574 is displayed with other DTC, first perform the trouble diagnosis for other DTC.

Is applicable DTC detected?

YES>>

Perform diagnosis of applicable. Refer to DTC Index.

NO>>

GO TO 2.

PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

  1. Ignition switch OFF and wait at least 10 seconds.

  2. Ignition switch ON.

  3. Ignition switch OFF and wait at least 10 seconds.

>>

GO TO 3.

PERFORM DTC CONFIRMATION PROCEDURE

  1. Start engine.

  2. Drive the Nissan Ariya vehicle at more than 40 km/h (25 MPH).

    CAUTION:

    Always drive vehicle at a safe speed.

    NOTE:

    This procedure may be conducted with the drive wheels lifted in the shop or by driving the Nissan Ariya vehicle. If a road test is expected to be easier, it is unnecessary to lift the vehicle.

  3. Check DTC.

Is DTC detected?

YES>>

Proceed to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

CHECK DTC PRIORITY

If DTC P1574 is displayed with other DTC, first perform the trouble diagnosis for other DTC.

Is applicable DTC detected?

YES>>

Perform diagnosis of applicable. Refer to DTC Index.

NO>>

GO TO 2.

CHECK DTC WITH TCM

Check DTC with TCM. Refer to CONSULT Function.

Is DTC detected?

NO>>

GO TO 3.

YES>>

Perform trouble shooting relevant to DTC indicated.

CHECK DTC WITH “ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)”

Check DTC with ABS actuator and electric unit (control unit). Refer to CONSULT Function.

Is DTC detected?

NO>>

INSPECTION END

YES>>

Perform trouble shooting relevant to DTC indicated.

    P1572 Ascd Brake Switch
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P1572 00 ASCD BRAKE SW (ASCD brake switch) Diagnosis condition S...
    P1574 Propilot Assist Vehicle Speed Sensor
    DTC Description The ECM receives two ProPILOT Assist vehicle speed sensor signals via CAN communication line. One is sent from combination meter, and the other is from TCM (tram...

    Other materials:

    Preparation
    Special Service Tools The actual shapes of TechMate tools may differ from those of special service tools illustrated here. Tool number (TechMate No.) Tool name Description (NI-39570) Chassis ear Locates the noise (NI-50397) NISSAN Squeak and Rattle Kit Repairs the ...

    Ecu Diagnosis Information. Electrically-Driven Intelligent Brake Unit
    DTC Index DTC Display item Brake warning lamp Brake system warning lamp Refer to B14E0-02 Wheel sensor OFF ON DTC Description B14E0-09 Wheel sensor OFF ON DTC Description B14E0-11 Wheel sensor OFF ON DTC Description B14E0-12 Wheel sensor ...

    P155e Generator Voltage
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P155E 00 GENERATOR VOLTAGE (GENERATOR VOLTAGE) Diagnosis condition Ignition switch ON Signal (terminal) Power supply Threshold Battery voltage measur ...