Nissan Rogue (T33) 2021-Present Service Manual: P1226 Tp Sensor

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
P1226 00

CTP LEARNING-B1

(CTP LEARNING-B1)
Diagnosis condition Ignition switch ON
Signal (terminal) Electric throttle control actuator signal
Threshold Closed throttle position learning is not performed successfully, repeatedly
Diagnosis delay time —

POSSIBLE CAUSE

Electric throttle control actuator (TP sensor 1 and 2)

FAIL-SAFE

Not applicable

DTC CONFIRMATION PROCEDURE

PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

  1. Turn ignition switch OFF and wait at least 10 seconds.

  2. Turn ignition switch ON.

  3. Turn ignition switch OFF and wait at least 10 seconds.

TESTING CONDITION:

Before performing the following procedure, confirm that battery voltage is more than 10 V at idle.

>>

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE

  1. Turn ignition switch ON.

  2. Turn ignition switch OFF and wait at least 10 seconds.

  3. Turn ignition switch ON.

  4. Repeat steps 2 and 3 for 32 times.

  5. Check 1st trip DTC.

Is 1st trip DTC detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

CHECK ELECTRIC THROTTLE CONTROL ACTUATOR VISUALLY

  1. Turn ignition switch OFF.

  2. Remove the electric throttle control actuator. Refer to Removal and Installation.

  3. Check if foreign matter is caught between the throttle valve and the housing

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Remove the foreign matter and clean the electric throttle control actuator inside, then perform throttle valve closed position learning. Refer to Work Procedure.

REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR

Replace electric throttle control actuator. Refer to Removal and Installation.

>>

INSPECTION END

    P1225 Tp Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P1225 00 CTP LEARNING-B1 (CTP LEARNING-B1) Diagnosis condition I...
    P12a8 Cruise Control
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detecting condition P12A8 00 Cruise control communication (Cruise control) Diagnosis...

    Other materials:

    System Description. System
    Power Seat System System Description Power seat can be operated regardless of ignition switch status, because power supply is always supplied to the power seat switch.SLIDING OPERATIONWhile operating the sliding switch located in the power seat switch, the sliding motor operates and makes se ...

    Other supplemental front-impact air bag precautions
    WARNING Do not place any objects on the steering wheel pad or instrument panel. Do not place objects between any occupant and the steering wheel or instrument panel. These may turn into dangerous projectiles if the front air bags deploy. Do not place sharp-edged objects or heavy items on ...

    Dtc/circuit Diagnosis. C161a-82 Abs System
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition C161A 82 ABS system (Anti-lock braking system ) Diagnosis condition When ignition switch is ON. Signal (terminal) CAN communication signal Threshold ...