Nissan Rogue (T33) 2021-Present Service Manual: P1225 Tp Sensor

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / P1225 Tp Sensor

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
P1225 00

CTP LEARNING-B1

(CTP LEARNING-B1) 		Diagnosis condition Ignition switch ON
Signal (terminal) Electric throttle control actuator signal
Threshold Closed throttle position learning value is excessively low
Diagnosis delay time —

POSSIBLE CAUSE

Electric throttle control actuator (TP sensor 1 and 2)

FAIL-SAFE

Not applicable

DTC CONFIRMATION PROCEDURE

PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

  1. Turn ignition switch OFF and wait at least 10 seconds.

  2. Turn ignition switch ON.

  3. Turn ignition switch OFF and wait at least 10 seconds.

TESTING CONDITION:

Before performing the following procedure, confirm that battery voltage is more than 10 V at idle.

>>

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE

  1. Turn ignition switch ON.

  2. Turn ignition switch OFF and wait at least 10 seconds.

  3. Turn ignition switch ON.

  4. Check 1st trip DTC.

Is 1st trip DTC detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

CHECK ELECTRIC THROTTLE CONTROL ACTUATOR VISUALLY

  1. Turn ignition switch OFF.

  2. Remove the electric throttle control actuator. Refer to Removal and Installation.

  3. Check if foreign matter is caught between the throttle valve and the housing

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Remove the foreign matter and clean the electric throttle control actuator inside, then perform throttle valve closed position learning. Refer to Work Procedure.

REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR

Replace electric throttle control actuator. Refer to Removal and Installation.

>>

INSPECTION END

    P1217 Engine Over Temperature
    DTC Description DTC DETECTION LOGICIf the cooling fan or another component in the cooling system malfunctions, engine coolant temperature will rise.When the engine coolant tempe...
    P1226 Tp Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P1226 00 CTP LEARNING-B1 (CTP LEARNING-B1) Diagnosis condition I...

    Other materials:

    Removal and Installation. Automatic Back Door Control Unit
    Removal and Installation REMOVALRemove luggage side lower finisher LH. Refer to Removal and Installation. Disconnect automatic back door control unit harness connector. Remove the automatic back door control unit mounting nuts (A), and then remove the automatic back door control unit (1). INST ...

    P0261 Fuel Injector (cylinder 1)
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0261 00 CYL1 INJECTOR (Cylinder 1 Injector A Circuit Low) Diagnosis condition — Signal (terminal) — Threshold Direct injector driver unit ...

    Abs Branch Line Circuit
    Diagnosis Procedure CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side). ABS actuator and electric unit (control u ...