Nissan Rogue (T33) 2021-Present Service Manual: P0607 Ecm

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / P0607 Ecm

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
P0607 00

ECM

(Control module performance) 		Diagnosis condition Ignition switch ON
Signal (terminal) —
Threshold ECM internal communication system is malfunctioning.
Diagnosis delay time —

POSSIBLE CAUSE

ECM

FAIL-SAFE

Engine Control System

Not applicable

Stop/Start System

When a DTC is detected, the stop/start indicator lamp blinks slowly and the stop/start system operation is prohibited. When ECM detects error while operating the stop/start system, ECM restarts the engine.

DTC Confirmation Procedure

PRECONDITIONING

  1. Turn ignition switch OFF and wait at least 10 seconds.

  2. Turn ignition switch ON.

  3. Turn ignition switch OFF and wait at least 10 seconds.

TESTING CONDITION:

Before performing the following procedure, confirm that battery voltage is 11 V or more with ignition switch ON.

>>

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE

  1. Turn ignition switch ON (engine stopped) and wait least 10 seconds.

  2. Turn ignition switch OFF and wait at least 10 seconds.

  3. Turn ignition switch ON.

  4. Check 1st trip DTC.

Is 1st trip DTC detected?

YES>>

Proceed to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

PERFORM DTC CONFIRMATION PROCEDURE

  1. Turn ignition switch ON.

  2. Erase DTC.

  3. Perform DTC confirmation procedure. Refer to DTC Description.

Is the 1st trip DTC P0607 displayed again?

YES>>

Replace ECM. Refer to ECM : Removal & Installation.

NO>>

INSPECTION END

    P0606 Ecm
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0606 00 CONTROL MODULE (Control module processor) Diagnosis con...
    P060a Ecm
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P060A 00 CONTROL MODULE (Internal control module monitoring proc...

    Other materials:

    Preparation
    Commercial Service Tools Tool Description Power tool Loosening screws Sealant or/and Lubricant Name Description Primer (3M K500, K520 or equivalent) Primer for attaching sonar sensor holder to bumper ...

    C1f07-62 Side Radar (rear Right) Circuit
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition C1F07 62 Side radar (Rear right) circuit Diagnosis condition When engine is running Signal (terminal) Brake pedal position switch signal Threshold Brak ...

    Dtc/circuit Diagnosis. Passenger Door Mirror Control Module
    Diagnosis Procedure CHECK FUSE Ignition switch OFF. Check that the following fuse is not blown (open): Unit Location Fuse No. Capacity Passenger door mirror control module Fuse block (J/B) 45 5 A   Is the fuse blown (open) ? YES>> Replace the bl ...