Nissan Rogue (T33) 2021-Present Service Manual: P0562 Sub Starter & Generator

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
P0562 00

Sub starter & generator

(Sub starter & generator)
Diagnosis condition Engine running at idle
Signal (terminal) CAN communication signal
Threshold 12V battery voltage decreases to 8 V or less
Diagnosis delay time 10 seconds or more

POSSIBLE CAUSE

  • Harness or connectors (12V battery voltage circuits are open or short circuit)

  • 12V battery

FAIL-SAFE

Engine Control System

Not applicable

Stop/Start System

When a DTC is detected, the stop/start indicator lamp blinks slowly and the stop/start system operation is prohibited. When ECM detects error while operating the stop/start system, ECM restarts the engine.

DTC CONFIRMATION PROCEDURE

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Start the engine and let it idle and wait for 10 second or more.

  2. Perform “Self Diagnostic Result” mode of “ECM”.

Is DTC detected?

YES>>

Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: Inspection end.

Diagnosis Procedure

CHECK CAN COMMUNICATION CIRCUIT

Perform the trouble diagnosis for CAN communication system. Refer to Trouble Diagnosis Flow Chart.

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair or replace error-detected parts.

CHECK DTC WITH SUB STARTER & GENERATOR

Check DTC with sub starter & generator. Refer to CONSULT Function (SUB STARTER & GENERATOR).

Is DTC C1C91-A2 detected?

YES>>

GO TO 3.

NO>>

Repair or replace error-detected parts.

CHECK SUB STARTER & GENERATOR

Check sub starter & generator. Refer to Diagnosis Procedure.

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Repair or replace error-detected parts.

    P0561 Sub Starter & Generator
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0561 00 Sub starter & generator (Sub starter & generato...
    P0573 Brake Pedal Switch a
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0573 Brake pedal switch A (Brake Switch "A" Circuit High) Diagn...

    Other materials:

    System
    Propilot Assist 2.1 System Description SYSTEM DIAGRAM Component Description ADAS control unit 2 ADAS Control Unit GNSS antenna ROOF ANTENNA AND ANTENNA FEEDER HD map module HD MAP MODULE Front camera unit Front Camera Unit Steering assist switch Steering As ...

    Mac Key Writing
    Description When replacing around view monitor control unit, it is necessary to write MAC key to around view monitor control unit. Write MAC key to around view monitor control unit according to "MAC Key writing" procedure of "CONSULT Operation Manual". Refer to Work Procedure.CAUTION: During ...

    Service Data and Specifications (sds)
    General Specifications BRAKE SYSTEMJAPAN PRODUCTION MODELS WITHOUT ProPILOT Assist 2.1Unit: mm (in) Front brake Cylinder bore diameter 60.33 (2.3752) Pad length × width × thickness 123.6 × 53.5 × 10.5 (4.87 × 2.106 × 0.413) Rotor outer diameter × thickness 296 × 26.0 ( ...