Nissan Rogue (T33) 2021-Present Service Manual: P053e Crankcase Pressure Sensor
DTC Description
DTC DETECTION LOGIC
| DTC |
CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition | ||
| P053E | 00 |
Crankcase Pressure Too High (Crankcase Pressure Too High) |
Diagnosis condition | Ignition switch ON |
| Signal (terminal) | - | |||
| Threshold | Crankcase pressure is out of the normal range | |||
| Diagnosis delay time | 5 seconds | |||
POSSIBLE CAUSE
-
Harness or connectors
(Crankcase pressure sensor circuit is open or shorted.)
-
Crankcase pressure sensor
-
ECM
FAIL-SAFE
Not applicable
DTC Confirmation Procedure
PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
-
Turn ignition switch OFF and wait at least 10 seconds.
-
Turn ignition switch ON.
-
Turn ignition switch OFF and wait at least 10 seconds.
>>
GO TO 2.
PERFORM DTC CONFIRMATION PROCEDURE
-
Turn ignition switch ON.
-
Wait at least 10 seconds.
Is DTC detected?
YES>>Proceed to DTC Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
DTC Diagnosis Procedure
CHECK CRANKCASE PRESSURE SENSOR CIRCUIT
Check crankcase pressure sensor circuit. Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Repair or replace error-detected parts.
PERFORM DTC CONFIRMATION PROCEDURE
Perform DTC Confirmation Procedure. Refer to DTC Description.
Is DTC detected again?
YES>>Replace ECM. Refer to ECM : Removal & Installation.
NO>>INSPECTION END
Other materials:
Intelligent Key operation (models with
request switch)
Example
Example
You can conveniently lock or unlock the doors of your Nissan Rogue without taking the key out of your pocket or bag.
When you carry the Intelligent Key with you, the Nissan Rogue allows controlling all doors by pressing the door handle request switch
A (front doors) or the liftg ...
Cvt: Ge0f14a. Symptom Diagnosis
Cvt Control System
Symptom Table
The diagnosis item number indicates the order of check. Start checking in the order from 1.
Perform diagnoses of symptom table 1 before symptom table 2.
Symptom Table 1 Diagnostic item Reference Symptom
Shift Shock Slips/Will Not Engage Other
...
Chassis Can Communication 4 Circuit
Diagnosis Procedure
CHECK NETWORK DIAGNOSIS
Check the "Network diagnosis" results from CONSULT to see that the diagnostic CAN communication circuit have no malfunction.
Are the diagnostic CAN communication circuit normal?
YES>>
GO TO 2.
NO>>
Check and repair diagnostic CAN commu ...
