Nissan Rogue (T33) 2021-Present Service Manual: P051c Crankcase Pressure Sensor

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
P051C 00

Crankcase Pressure Sensor "A" Circuit Low

(Crankcase Pressure Sensor "A" Circuit Low)
Diagnosis condition Ignition switch ON
Signal (terminal) -
Threshold Sensor output voltage is abnormal
Diagnosis delay time 5 seconds

POSSIBLE CAUSE

  • Harness or connectors

    (Crankcase pressure sensor circuit is open or shorted.)

  • Crankcase pressure sensor

  • ECM

FAIL-SAFE

Not applicable

DTC Confirmation Procedure

PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

  1. Turn ignition switch OFF and wait at least 10 seconds.

  2. Turn ignition switch ON.

  3. Turn ignition switch OFF and wait at least 10 seconds.

>>

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE

  1. Start engine and let it idle at least 10 seconds.

  2. Check DTC.

Is DTC detected?

YES>>

Proceed to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

CHECK CRANKCASE PRESSURE SENSOR CIRCUIT

Check crankcase pressure sensor circuit. Refer to DTC Diagnosis Procedure.

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair or replace error-detected parts.

PERFORM DTC CONFIRMATION PROCEDURE

Perform DTC Confirmation Procedure. Refer to DTC Description.

Is DTC detected again?

YES>>

Replace ECM. Refer to ECM : Removal & Installation.

NO>>

INSPECTION END

    P050a Cold Start Control
    DTC Description DESCRIPTIONECM controls ignition timing and engine idle speed when engine is started with pre-warming up condition.This control promotes the activation of three ...
    P0520 Eop Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0520 00 EOP SENSOR/SWITCH (Engine oil pressure sensor/switch A ...

    Other materials:

    P026b Injection Timing
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P026B 00 Injection timing Diagnosis condition — Signal — Threshold ECM does not control fuel injection timing properly when engine is running ...

    Informations de base et fonctionnement
    Exemple d'affichage dynamique L’affichage tête haute (Head-Up Display ou HUD) du Nissan Rogue est une technologie de pointe conçue pour projeter les données de conduite essentielles directement dans votre champ de vision. Cette innovation permet au conducteur du Nissan Rogue de rester co ...

    Réglages
    Informations de base Le mode de réglages permet à l’utilisateur de personnaliser les informations affichées sur l’écran d’informations du véhicule ainsi que plusieurs paramètres de fonctionnement du Nissan Rogue. Ces réglages offrent une adaptation fine du véhicule selon vos préfére ...