Nissan Rogue (T33) 2021-Present Service Manual: P0462 Fuel Level Sensor

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / P0462 Fuel Level Sensor

DTC Description

DTC DETECTION LOGIC

This diagnosis indicates the former, to detect open or short circuit malfunction.

DTC

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
P0462 00

FUEL LEVL SEN/CIRC

(Fuel level sensor ″A″ circuit low) 		Diagnosis condition Ignition switch ON
Signal (terminal) Fuel level sensor signal
Threshold An excessively low resistance from the sensor is sent to ECM
Diagnosis delay time —

POSSIBLE CAUSE

  • Harness or connectors

    • CAN communication line is open or shorted.

    • Fuel level sensor circuit is open or shorted.

  • Combination meter

  • Fuel level sensor

FAIL-SAFE

Not applicable

DTC Confirmation Procedure

CHECK DTC PRIORITY

If DTC P0462 is displayed with DTC UXXXX or P0607, first perform the trouble diagnosis for DTC UXXXX or P0607.

Is applicable DTC detected?

YES>>

Perform diagnosis of applicable. Refer to DTC Index.

NO>>

GO TO 2.

PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

TESTING CONDITION:

Before performing the following procedure, confirm that battery voltage is between 11 V and 16 V at ignition switch ON.

>>

GO TO 3.

PERFORM DTC CONFIRMATION PROCEDURE

  1. Turn ignition switch ON and wait at least 5 seconds.

  2. Check 1st trip DTC.

Is 1st trip DTC detected?

YES>>

Proceed to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

CHECK DTC PRIORITY

If DTC P0462 is displayed with DTC UXXXX or P0607, first perform the trouble diagnosis for DTC UXXXX or P0607.

Is applicable DTC detected?

YES>>

Perform diagnosis of applicable. Refer to DTC Index.

NO>>

GO TO 2.

CHECK COMBINATION METER FUNCTION

Refer to Component Function Check (FULL TFT METER) or Component Function Check (7 INCH INFORMATION DISPLAY).

Is the inspection result normal?

YES>>

Check intermittent incident. Refer to Intermittent Incident.

NO>>

Proceed to Work flow (FULL TFT METER) or Work flow (7 INCH INFORMATION DISPLAY).

    P0461 Fuel Level Sensor
    DTC Description DTC DETECTION LOGICDriving long distances naturally affect fuel gauge level.This diagnosis detects the fuel gauge malfunction of the gauge not moving even after ...
    P046e Egr Differential Pressure Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P046E 00 EGR SENSOR B (EGR sensor B circuit range/performance) D...

    Other materials:

    Dtc/circuit Diagnosis. B1000-49 Air Bag Diagnosis Sensor Unit
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition B1000-49 Air bag diagnosis sensor unit (Air bag diagnosis sensor unit) Diagnosis condition When ignition switch is ON. Signal (terminal) — Threshold ...

    Window washer fluid
    Type A (if so equipped) Type B (if so equipped) For Type A systems on the Nissan Rogue, check the washer reservoir directly and refill with washer fluid when the level gets low. For Type B systems, plug the center hole A of the cap/tube assembly with your finger and remove it from the re ...

    Steering Switch Signal B Circuit
    Component Function Check CHECK COMBINATION METER INPUT SIGNAL CONSULT Ignition switch ON. Select “Steering switch input” in “Data monitor” mode of “M&A”. Check that the function operates normally according to the following conditions: Condition Value CONTRO ...