Nissan Rogue (T33) 2021-Present Service Manual: P0460 Fuel Level Sensor
DTC Description
DTC DETECTION LOGIC
When the vehicle is parked, naturally the fuel level in the fuel tank is stable. It means that output signal of the fuel level sensor does not change. If ECM senses sloshing signal from the sensor, fuel level sensor malfunction is detected.
| DTC |
CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition | ||
| P0460 | 00 |
FUEL LEV SEN SLOSH (Fuel Level Sensor ″A″ Circuit) |
Diagnosis condition | Engine running at idle |
| Signal (terminal) | Fuel level sensor signal | |||
| Threshold | Even though the Nissan Ariya vehicle is parked, a signal being varied is sent from the fuel level sensor to ECM | |||
| Diagnosis delay time | — | |||
POSSIBLE CAUSE
-
Harness or connectors
-
CAN communication line is open or shorted.
-
Fuel level sensor circuit is open or shorted.
-
-
Combination meter
-
Fuel level sensor
FAIL-SAFE
Not applicable
DTC Confirmation Procedure
CHECK DTC PRIORITY
If DTC P0460 is displayed with DTC UXXXX or P0607, first perform the trouble diagnosis for DTC UXXXX or P0607.
Is applicable DTC detected?
YES>>Perform diagnosis of applicable. Refer to DTC Index.
NO>>GO TO 2.
PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
-
Turn ignition switch OFF and wait at least 10 seconds.
-
Turn ignition switch ON.
-
Turn ignition switch OFF and wait at least 10 seconds.
>>
GO TO 3.
PERFORM DTC CONFIRMATION PROCEDURE
-
Start engine and wait maximum of 2 consecutive minutes.
-
Check 1st trip DTC.
Is 1st trip DTC detected?
YES>>Proceed to DTC Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
DTC Diagnosis Procedure
CHECK DTC PRIORITY
If DTC P0460 is displayed with DTC UXXXX or P0607, first perform the trouble diagnosis for DTC UXXXX or P0607.
Is applicable DTC detected?
YES>>Perform diagnosis of applicable. Refer to DTC Index.
NO>>GO TO 2.
CHECK COMBINATION METER FUNCTION
Refer to CONSULT Function (FULL TFT METER) or CONSULT Function (7 INCH INFORMATION DISPLAY).
Is the inspection result normal?
YES>>Check intermittent incident. Refer to Intermittent Incident.
NO>>Refer to Component Function Check (FULL TFT METER) or Component Function Check (7 INCH INFORMATION DISPLAY).
Other materials:
P1564 Ascd Steering Switch
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P1564
00
ASCD SW
(ASCD SW)
Diagnosis condition
—
Signal (terminal)
ASCD steering switch signal
Threshold
ECM detects that input signal from t ...
Wiring Diagram. Harness Layout
Outline
Harness Layout
Refer to Harness Layout.
Engine Room Harness
Harness Layout
ENGINE ROOM HARNESS - BATTERY VIEW (WITH ProPILOT Assist 2.1)Refer to Harness Layout.ENGINE ROOM HARNESS - BATTERY VIEW (WITHOUT ProPILOT Assist 2.1)Refer to Harness Layout.ENGINE ROOM HARNESS - CABIN VIEW (WITH Pr ...
Adas Control Unit. Basic Inspection
Additional Service When Replacing Adas Control Unit 2
Without Propilot Assist 2.1
Work Procedure
Always perform the additional service after replacing the ADAS control unit 2.ADAS CONTROL UNIT 2 CONFIGURATION
Perform saving Nissan Ariya vehicle internal information according to "Replace ECU" i ...
