Nissan Rogue (T33) 2021-Present Service Manual: P044b Egr Volume Control Valve Position Sensor

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / P044b Egr Volume Control Valve Position Sensor

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
P044B 00

EGR SENSOR C

(EGR Sensor "C" Circuit Range/Performance) 		Diagnosis condition After warming up, switch OFF the ignition every time the engine is stopped.
Signal (terminal) ―
Threshold When EGR volume control valve is fully closed or fully opened, sensor output is out of the specified range.
Diagnosis delay time 3 seonds or more

POSSIBLE CAUSE

EGR volume control valve failure (sensor failure, internal gear damage, valve movement is not smooth)

FAIL-SAFE

Fail safe mode Nissan Ariya Vehicle behavior
Traveling control mode Accelerator angle variation control

ECM controls the accelerator pedal depression speed to make it slower than actual speed. This causes a drop in accelerating performance and encourages the driver to repair malfunction.

NOTE:

ECM does not control the accelerator pedal releasing speed.
Device fix mode

  • This mode fixes the electric IVT control actuator and the EVT control solenoid valve in the reference position.

  • A control signals is not transmitted to the EGR volume control valve and the EGR volume control is deactivated.

DTC CONFIRMATION PROCEDURE

PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

  1. Turn ignition switch OFF and wait at least 10 seconds.

  2. Turn ignition switch ON.

  3. Turn ignition switch OFF and wait at least 10 seconds.

>>

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE

  1. Start the engine and warm it up to normal operating temperature.

  2. Stop the engine.

  3. Switch ON the ignition and wait at least 3 seconds.

Is the DTC detected?

YES>>

Proceed to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

REPLACE EGR VOLUME CONTROL VALVE

Replace EGR volume control valve. Refer to Removal and Installation.

>>

INSPECTION END

    P044a Egr Volume Contro Valve Position Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P044A 00 EGR SENSOR C (EGR sensor C circuit low) Diagnosis condi...
    P044c Egr Volume Control Valve Position Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P044C 00 EGR SENSOR C (EGR sensor C circuit low) Diagnosis condi...

    Other materials:

    Its Can Communication 1 Circuit
    Diagnosis Procedure CHECK NETWORK DIAGNOSIS Check the "Network diagnosis" results from CONSULT to see that the diagnostic CAN communication circuit have no malfunction. Are the diagnostic CAN communication circuit normal? YES>> GO TO 2. NO>> Check and repair diagnostic CAN commu ...

    Symptom Diagnosis. Low Tire Pressure Warning Lamp Blinks
    Description When the ignition switch is placed ON, the low tire pressure warning lamp blinks. And then 1 minute later, low tire pressure warning lamp turns ON. Diagnosis Procedure CHECK TIRE PRESSURE SENSOR INSTALLATION Check visually that tire pressure sensors are installed to each wheels c ...

    Drivetrain Can Communication 2 Circuit
    Diagnosis Procedure CHECK NETWORK DIAGNOSIS Check the "Network diagnosis" results from CONSULT to see that the diagnostic CAN communication circuit have no malfunction. Are the diagnostic CAN communication circuit normal? YES>> GO TO 2. NO>> Check and repair diagnostic CAN commu ...