Nissan Rogue (T33) 2021-Present Service Manual: P00f2 Maf Sensor

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / P00f2 Maf Sensor

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
P00F2 00

Humidity Sensor Circuit/Open

(Humidity Sensor Circuit/Open) 		Diagnosis condition —
Signal (terminal) Humidity sensor　signal
Threshold An excessively High/Low voltage from the humidity sensor (Mass air flow sensor) is sent to ECM
Diagnosis delay time —

POSSIBLE CAUSE

  • Humidity sensor (Mass air flow sensor)

FAIL-SAFE

Not applicable

DTC CONFIRMATION PROCEDURE

DTC Confirmation Procedure

If DTC Confirmation Procedure has previously conducted,alwaiys peiform the following procedure before conducting the next tesut.

  1. Turn ignition switch OFF and wait at least 10 seconds.

  2. Turn ignition switch ON.

  3. Turn ignition switch OFF and wait at least 10 seconds.

Is DTC is detected?

>>

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE

  1. Start engine and wait at least 5 seconds.

  2. Check DTC.

Is DTC detected?

YES>>

Proceed to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

REPLACE MASS AIR FLOW SENSOR

Replace Mass air flow sensor. Refer to Exploded View.

>>

INSPECTION END

    P00e0 Charge Air Cooler Coolant Temperature Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P00E0 00 Sub-Radiator Coolant Temperature Sensor Circuit Low (Ch...
    P00fe Evap Control System
    DTC Description This diagnosis detects clogs in the EVAP line between fuel tank and EVAP canister purge volume control solenoid valve.ECM controls EVAP control system as below. ...

    Other materials:

    Sheet Metal Work
    Sheet Metal Work Tools Sheet Metal Work Tools This section explains various tools used in body repair work. Hammers A hammer is used to correct dents, projections or other deformations. Various shapes have been designed according to their purposes.(1) TYPES AND FEATURES OF HAMMERS(2) SELECTI ...

    Symptom Diagnosis. Sunshade Does Not Operate Properly
    Description Sunshade does not operate normally. Sunshade open/close does not operate. Sunshade open/close operation is slow. Judder occurs during open/close operation of sunshade. Diagnosis Procedure CHECK SUNSHADE Check sunshade for damage, deformation, of interference with oth ...

    P054a Camshaft Position Bank 1
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P054A 00 Cold start B camshaft position bank 1 (Cold start B camshaft position timing over-advanced bank 1) Diagnosis condition Cold condition Signal (ter ...