Nissan Rogue (T33) 2021-Present Service Manual: Operation

Nissan Rogue (T33) 2021-Present Service Manual / Driver Information & Multimedia :: Meter, Warning Lamp & Indicator / Type B :: System Description / Operation

Switch Name and Function

STEERING SWITCH

Screen of information display can be switched by operating the steering switch.

No. Switch name Operation Description
RIGHT switch Press Switches the screen shown on the information display.
LEFT/BACK switch Press

  • Switches the screen shown on the information display.

  • Switches the screen shown on the information display to the previous screen.
OK switch Press Switches the screen shown on the information display.
Jog dial Up

  • Moves up the item selected on the information display.

  • Increases the set value displayed on the settings screen of the information display.
Down

  • Moves down the item selected on the information display.

  • Decreases the set value displayed on the settings screen of the information display.
Control switch Press Switches the screen shown on the information display to the short cut menu screen.

METER CONTROL SWITCH

The brightness of combination meter and information display can be adjusted by pressing the illumination control switch (+/−)

No. Switch name Operation Description
Illumination control switch (+) Press The brightness of combination meter and information display can be adjusted.
Illumination control switch (−)
    System
    Meter System System Description SYSTEM DIAGRAM Parts name Description Ambient sensor Refer to Ambient Sensor. BCM Transmits the BCM status to the combination meter via CAN commu...
    Diagnosis System (combination Meter)
    On Board Diagnosis Function ON BOARD DIAGNOSIS ITEMThe following meter functions can be checked during combination meter self-diagnosis mode: Pointer sweep of speedometer, tacho...

    Other materials:

    Dtc/circuit Diagnosis. Front Washer Circuit
    Component Function Check CHECK FRONT WASHER OPERATION When the front washer switch is turned to the ON position the front washer should operate. Is front washer operation normal? YES>> Washer switch circuit is normal. NO>> Refer to Diagnosis Procedure. Diagnosis Procedure COMB ...

    Removal and Installation. Electrically-Driven Intelligent Brake Unit
    Exploded View Reservoir cap Oil strainer Electrically-driven intelligent brake unit Clevis Gasket     : N·m (kg-m, ft-lb) : Always replace after every disassembly. Removal & Installation REMOVALCAUTION: While electrically-driven ...

    P11b0 Vcr Target Angle (cold Start)
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P11B0 00 VCR target angle (cold start) [Variable compression ratio target angle (cold start)] Diagnosis condition Engine cold start Signal (terminal) ...