Nissan Rogue Service Manual: O/D off indicator lamp
Component Function Check
1.CHECK O/D OFF INDICATOR LAMP FUNCTION
Check O/D OFF indicator lamp turns ON for approx. 2 seconds when ignition switch turns ON.
Is the inspection results normal? YES >> INSPECTION END
NO >> Go to TM-181, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK DTC (TCM)
With CONSULT
- Turn ignition switch ON.
- Check “Self Diagnostic Results” in “TRANSMISSION”.
Is any DTC detected? YES >> Check DTC detected item. Refer to TM-63, "DTC Index".
NO >> GO TO 2.
2.CHECK DTC (COMBINATION METER)
With CONSULT
Check “Self Diagnostic Results” in “METER/M&A”.
Is any DTC detected? YES >> Check DTC detected item. Refer to MWI-30, "DTC Index".
NO >> GO TO 3.
3.CHECK COMBINATION METER INPUT/OUTPUT SIGNAL
With CONSULT
- Shift the selector lever to “D” position.
- Select “Data Monitor” in “METER/M&A”.
- Select “O/D OFF IND”.
- Check that “O/D OFF IND” turns ON/OFF when overdrive control switch is operated. Refer to MWI-24, "Reference Value".
Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-82, "Removal and Installation".
NO >> GO TO 4.
4.CHECK TCM INPUT/OUTPUT SIGNAL
With CONSULT
- Select “Data Monitor” in “TRANSMISSION”.
- Select “SPORT MODE SW”.
- Check that “SPORT MODE SW” turns ON/OFF when overdrive control switch is operated. Refer to TM- 52, "Reference Value".
Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-82, "Removal and Installation".
NO >> Check overdrive control switch circuit. Refer to TM-178, "Diagnosis Procedure".
Overdrive control switch
Component Function Check
1.CHECK O/D OFF INDICATOR LAMP FUNCTION
Check O/D OFF indicator lamp turns ON for approx. 2 seconds when ignition
switch turns ON.
Is the inspection results normal?
YE ...
Shift position indicator circuit
Component Parts Function Inspection
1.CHECK SHIFT POSITION INDICATOR
Start the engine.
Shift selector lever.
Check that the selector lever position and the shift position
...
Other materials:
B1428 seat belt buckle switch IH
Description
DTC B1428 SEAT BELT BUCKLE SWITCH LH
The air bag diagnosis sensor unit monitors the seat belt buckle switch LH
status. If the control unit detects an
open or short condition in the circuit, it will set the DTC.
PART LOCATION
Refer to SRC-6, "Component Parts Location".
D ...
Wiring diagram
POWER DISTRIBUTION SYSTEM
Wiring Diagram
...
P0965 pressure control solenoid B
DTC Description
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P0965
PC SOLENOID B
(Pressure Control Solenoid B Control Circuit
Range Performance)
When any of 1 or 2 is satisfied and this state is maintained for ...
