Nissan Rogue Service Manual: Shift position indicator circuit
Component Parts Function Inspection
1.CHECK SHIFT POSITION INDICATOR
- Start the engine.
- Shift selector lever.
- Check that the selector lever position and the shift position indicator on the combination meter are identical.
Is the inspection result normal? YES >> INSPECTION END
NO >> Go to TM-182, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK TCM INPUT/OUTPUT SIGNAL
With CONSULT
- Start the engine.
- Select “Data Monitor” in “TRANSMISSION”.
- Select “RANGE”.
- Shift selector lever.
- Check that selector lever position, “RANGE” on CONSULT screen, and shift position indicator display on combination meter are identical.
Is the check result normal? YES >> INSPECTION END
NO-1 (“RANGE” is changed but is not displayed on shift position indicator.>>Check “Self Diagnostic Result” in “TRANSMISSION”.
NO-2 (“RANGE” and shift position indicator are different.)>>Check “Self Diagnostic Result” in “TRANSMISSION”.
NO-3 (Specific “RANGE” is not displayed on shift position indicator.)>>Check “Self Diagnostic Result” in “METER/M&A”.
O/D off indicator lamp
Component Function Check
1.CHECK O/D OFF INDICATOR LAMP FUNCTION
Check O/D OFF indicator lamp turns ON for approx. 2 seconds when ignition
switch turns ON.
Is the inspection results normal?
YE ...
Shift lock system
Component Function Check
1.CHECK SHIFT LOCK OPERATION (PART 1)
Turn ignition ON.
Shift the selector lever to “P” position.
Attempt to shift the selector lever to any oth ...
Other materials:
Vehicle identification
Vehicle identification number (VIN) plate
The vehicle identification number (VIN) plate is
located as shown. This number is the identification
for your vehicle and is used in the vehicle
registration.
The VIN number is also available through the
center display screen. For additional inf ...
Unit disassembly and assembly
COMBINATION METER
Exploded View
Combination meter
Combination meter lens
Pawl
Disassembly and Assembly
CAUTION:
Do not touch the display, pointer, inside of combination meter
or the printed area of the dial during
disassembly or assembly.
Keep away from magn ...
Retained power operation does not operate properly
Diagnosis Procedure
1.CHECK FRONT DOOR SWITCH
Check (LH and RH) front door switches.
Refer to DLK-24, "Front Door Switch".
Is the inspection result normal?
YES >> GO TO 2.
NO >> Repair or replace the malfunctioning parts.
2.CONFIRM THE OPERATION
Confirm the operat ...
