Nissan Rogue (T33) 2021-Present Owner’s Manual & User Guide: Manual operation

Nissan Rogue (T33) 2021-Present Owner’s Manual & User Guide / Monitor, heater, air conditioner, audio and phone systems / Heater and air conditioner / Manual operation

Fan speed control:
Press to increase or decrease fan speed manually.

Air intake control:
Each press of toggles between:

  • Recirculated air (indicator ON)
  • Outside air (indicator OFF)
  • Press and hold for 2 seconds to return to AUTO intake control

Air flow control:
Press to select:

– Center & side vents

– Center/side & foot outlets

– Foot outlets & partial defrost

– Defroster & foot outlets

Synchronize temperature settings:

Press SYNC (indicator ON) to make the driver’s dial control both sides.

Adjusting the passenger dial turns SYNC OFF.

To turn the system off:
Press ON·OFF.

Remote engine start with intelligent climate control (if equipped)

With remote start active, the Nissan Rogue automatically heats or cools the cabin based on inside/outside temperatures. Controls remain locked until the ignition is switched ON. During cold weather, rear defrost and heated steering (if equipped) may activate automatically.

    Automatic air conditioner (models without rear control)
    Models with heated steering wheel Models without heated steering wheel Basic information Temperature control dial (driver's side) AUTO button Display screen SYNC button Temperat...
    Automatic air conditioner (models with rear control)
    Basic information Temperature control dial (driver's side) AUTO button Air recirculation button Outside air button Display screen SYNC button Temperature control dial (passenger...

    Other materials:

    U0164 Can Communication
    DTC Description CAN (Controller Area Network) is a serial communication line for real time application. It is an on-Nissan Ariya vehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control units are equipped onto a N ...

    Dtc/circuit Diagnosis. Hazard Function
    Component Function Check CHECK FUNCTION CONSULT Select “Flasher” in “Active test” mode of "BCM". Touch “LH” or “RH” to check that it works normally. Is the inspection result normal? YES>> Hazard warning lamp circuit is OK. NO>> Refer to Diagnosis Pr ...

    Steering Switch Signal a Circuit
    Component Function Check PERFORM COMPONENT FUNCTION CHECK With CONSULT Check “Self Diagnostic Result” of “MULTI AV”. Is any DTC detected? YES>> Perform the trouble diagnosis for the detected DTC. Refer to DTC Index. NO>> Proceed to Diagnosis Procedure. Diagnosis Proced ...