Nissan Rogue (T33) 2021-Present Service Manual: Main Line Between Tcm and E-Shift Circuit

Nissan Rogue (T33) 2021-Present Service Manual / Electrical & Power Control :: Lan System / Can :: Dtc/circuit Diagnosis / Main Line Between Tcm and E-Shift Circuit

Diagnosis Procedure

CHECK CONNECTOR

  1. Turn the ignition switch OFF.

  2. Disconnect the battery cable from the negative terminal.

  3. Check the following terminals and connectors for damage, bend and loose connection (connector side and harness side).

    • Harness connector F37

    • Harness connector E22

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair the terminal and connector.

CHECK HARNESS CONTINUITY (OPEN CIRCUIT)

  1. Disconnect the following harness connectors.

    • CVT unit

    • Harness connectors F37 and E22

  2. Check the continuity between the CVT unit harness connector and the harness connector.

    CVT unit harness connector Harness connector Continuity
    Connector No. Terminal No. Connector No. Terminal No.
    F70 11 F37 3 Existed
    4 19 Existed

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair the main line between the CVT unit and the harness connector F37.

CHECK HARNESS CONTINUITY (OPEN CIRCUIT)

  1. Disconnect the connector of electric shift control module.

  2. Check the continuity between the harness connector and the electric shift control module harness connector.

    Harness connector Electric shift control module harness connector Continuity
    Connector No. Terminal No. Connector No. Terminal No.
    E22 3 E131 31 Existed
    19 32 Existed

Is the inspection result normal?

YES (Present error)>>

Check CAN system type decision again.

YES (Past error)>>

Error was detected in the main line between the CVT unit and the electric shift control module.

NO>>

Repair the main line between the harness connector E22 and the electric shift control module.

    Main Line Between Ccm and 4wd Circuit
    Diagnosis Procedure CHECK CONNECTOR Ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the following terminals and connectors for damage, bend a...
    Hfm Branch Line Circuit
    Diagnosis Procedure CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the Intelligent ...

    Other materials:

    U224a-87 Can Comm Err (awd/4wd)
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U224A 87 CAN comm err (AWD/4WD) [Controller area network communication error (AWD/4WD control unit)] 1 Diagnosis condition When ignition switch is ON. ...

    Dtc/circuit Diagnosis. C1731-16 Tire Pressure Sensor Fl
    DTC Description NOTE: The Signal Tech II Tool [– (NI-50190)] can be used to perform the following functions: Refer to the Signal Tech II User Guide for additional information. Activate and display TPMS sensor IDs Display tire pressure reported by the TPMS sensor Read TPMS DTCs ...

    C0513 Wheel Speed Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition C0513 00 Right rear wheel speed sensor (Right Rear Wheel Speed Sensor Range/Performance) Diagnosis condition Ignition switch ON Battery voltage: 11 V ...