Nissan Rogue (T33) 2021-Present Service Manual: Kr15ddt :: Service Data and Specifications (sds). Service Data and Specifications (sds)

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Service Data and Specifications (sds). Service Data and Specifications (sds)

Service Data and Specifications (sds)

IDLE SPEED : Service Data

Condition Specification
No load* (in P or N position)

2WD：750 ± 50 rpm

4WD：800 ± 50 rpm

*: Under the following conditions

  • A/C switch: OFF

  • Electric load: OFF (Lights, heater fan & rear window defogger)

  • Steering wheel: Kept in straight-ahead position

CALCULATED LOAD VALUE : Service Data

Condition Specification (Using CONSULT or GST)
At idle 5 – 35 %
At 2,500 rpm 5 – 35 %

MASS AIR FLOW SENSOR : Service Data

Supply voltage 5 V
Mass air flow (Using CONSULT or GST)

2.09 – 3.51 g/s 1,500 rpm*

3.62 – 6.40 g/s at 2,500 rpm*

*: Engine is warmed up to normal operating temperature and running under no load.

IGNITION TIMING : Service Data

Condition Specification
2WD 4WD
No load* (in P or N position) Intake air temperature : less than 30°C (86°F) 3.5 ± 5° BTDC –1 ± 5° BTDC
Other than above –1.5 ± 5° BTDC –4 ± 5° BTDC

*: Under the following conditions

  • A/C switch: OFF

  • Electric load: OFF (Lights, heater fan & rear window defogger)

  • Steering wheel: Kept in straight-ahead position

    Kr15ddt. Removal and Installation
    Ecm ECM : Exploded View 1. ECM 2. Bracket     ECM : Removal & Installation CAUTION: Perform ADDITIONAL SERVICE WHEN REPLACING ECM. Refer to Work Procedure. When re...
    Engine. Fuel System

    Other materials:

    Fuel Level Sensor Signal Circuit
    Component Function Check PERFORM COMPONENT FUNCTION CHECK (1) Ignition switch OFF. Disconnect fuel level sensor unit, fuel pump and FPCM (fuel level sensor) (main) harness connector. Connect variable resistor between harness connector terminals located on the Nissan Ariya vehicle s ...

    2wd. Symptom Diagnosis. Noise, Vibration and Harshness (nvh) Troubleshooting
    Noise, Vibration and Harshness (nvh) Troubleshooting NVH Troubleshooting Chart Use chart below to find the cause of the symptom. If necessary, repair or replace these parts. Possible cause and SUSPECTED PARTS Symptom Reference REAR AXLE Noise Shake Vibration Shimmy Judder Poor quality ...

    Illumination Control Switch Signal Circuit
    Component Function Check CHECK COMBINATION METER INPUT SIGNAL Ignition switch ON. Measure voltage between the following terminals of the combination meter. Combination meter Condition Voltage (Approx.) Connector Terminals (+) (−) M73 (U.S.A. production) ...