Nissan Rogue (T33) 2021-Present Service Manual: Ipdm E/r :: Basic Inspection
Additional Service When Replacing Ipdm E/r
Description
After replaced IPDM E/R, it is necessary to perform control unit configuration with CONSULT (for details, refer to Work Procedure).
AFTER REPLACEMENT
When replacing IPDM E/R, write vehicle specification with CONSULT vehicle configuration.
CAUTION:
Never perform vehicle configuration other than when performing configuration with a new IPDM E/R or the control function may not operate normally.
Work Procedure
REPLACE IPDM E/R
Replace IPDM E/R. Refer to Removal and Installation.
>>
GO TO 2.
WRITING Nissan Ariya Vehicle SPECIFICATION
Perform configuration (IPDM E/R). Refer to Description.
>>
Work End.
Configuration (ipdm E/r)
Description
Vehicle specification needs to be written with CONSULT because it is not written after replacing the IPDM E/R.
Configuration requires a network connection. CONSULT connects to the network and then downloads the configuration data from the server. Then CONSULT writes the Nissan Ariya vehicle specification to the IPDM E/R.
Refer to Work Procedure.
NOTE:
For details the network connection and operation, refer to “CONSULT Operation Manual�.
The configuration no need to “save� configuration data from the IPDM E/R. The configuration data is always generated freshly at the server and then downloaded to the CONSULT.
CAUTION:
-
Complete the procedure of “Configuration� in order.
-
If incorrect “Configuration�, incidents might occur.
-
Never perform “Configuration� except for a new IPDM E/R.
Work Procedure
WRITING VEHICLE SPECIFICATION
CONSULT
Perform writing Nissan Ariya vehicle specification to the IPDM E/R according to "Replace ECU" in "CONSULT Operation Manual".
>>
Work End.
Other materials:
Type B. Precaution. Precautions
Precautions
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG� and “SEAT BELT
PRE-TENSIONER�, used along with a front seat belt, helps to reduce the
risk or severity of injury to the driver and ...
Power Supply and Ground Circuit
Diagnosis Procedure
CHECK FUSE
Check that the following fuse is not blown:
Signal name Fuse No.
Ignition power supply
40 (10 A)
Is the fuse blown?
YES>>
Replace the blown fuse after repairing the affected circuit.
NO>>
GO TO 2.
CHECK ADAS CONTROL UNIT 2 POWER SUPP ...
Brake Warning Lamp
Component Function Check
CHECK BRAKE WARNING LAMP FUNCTION (1)
Check that brake warning lamp in combination meter turns ON for
approximately 1 second after ignition switch is ON (before engine
start).
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Refer to Diagnosis Pr ...
