Nissan Rogue (T33) 2021-Present Owner’s Manual & User Guide: How to enable/disable the I-BSI system

Nissan Rogue (T33) 2021-Present Owner’s Manual & User Guide / Starting and driving / Intelligent Blind Spot Intervention (I-BSI) / How to enable/disable the I-BSI system

Nissan Rogue Intelligent Blind Spot Intervention

  1. Press the button until “Settings” appears, then press the scroll dial.
  2. Select “Driver Assistance” using the scroll dial.
  3. Select “Blind Spot Assist” and press the scroll dial.
  4. Select “Intervention” to enable or disable the I-BSI system.

4. Push the ProPILOT Assist switch to turn the system on or off.

NOTE:

Turning on the ProPILOT Assist system will automatically activate both the I-BSI and I-LI systems.

If the BSW system is turned off, the I-BSI system will also be deactivated.

    I-BSI system operation
    Side indicator light I-BSI ON indicator I-BSI warning indicator Vehicle information display ProPILOT Assist switch The I-BSI system functions above approximately 37 MPH (60 km/h...
    I-BSI system limitations
    WARNING The following limitations apply to the Intelligent Blind Spot Intervention system. Failure to operate your vehicle in accordance with these limitations could result in s...

    Other materials:

    Type a. Removal and Installation
    Combination Meter Removal and Installation CAUTION: When replacing the combination meter, always replace it with a new one. The functions controlled by the combination meter does not operate properly in case of reuse of the combination meter from another Nissan Ariya vehicle. Be su ...

    Removal and Installation. 12v Battery Current Sensor
    Exploded View : 12V battery current sensor : Harness connector : N·m (kg-m, in-lb) Removal and Installation REMOVALDisconnect the 12V battery current sensor connector . Remove negative cable mounting nut , and then remove the negative cable . Loosen 12V battery cu ...

    2wd. Preparation. Preparation
    Preparation Special Service Tool Tool number (TechMate No.) Tool name Description KV40104000 ( – ) Hub lock nut wrench a: 85 mm (3.35 in) b: 65 mm (2.56 in) Removing and Installing wheel hub lock nut. KV40107300 ( – ) Boot band crimping tool Installing bo ...