Nissan Rogue (T33) 2021-Present Service Manual: Head up Display Switch Signal Circuit

Nissan Rogue (T33) 2021-Present Service Manual / Driver Information & Multimedia :: Meter, Warning Lamp & Indicator / Type a :: Dtc/circuit Diagnosis / Head up Display Switch Signal Circuit

Diagnosis Procedure

CHECK HEAD UP DISPLAY SWITCH SIGNAL CIRCUIT

  1. Ignition switch OFF.

  2. Disconnect Head Up Display unit harness connector and Head Up Display switch harness connector.

  3. Check continuity between Head Up Display unit harness connector and Head Up Display main switch harness connector.

    Head Up Display unit Head Up Display switch Continuity
    Connector Terminal Connector Terminal
    M110 13 M109 6 Yes

  4. Check continuity between Head Up Display unit harness connector and ground.

    Head Up Display unit Ground Continuity
    Connector Terminal
    M110 13 No

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair harness or connector.

CHECK HEAD UP DISPLAY SWITCH GROUND CIRCUIT

Check continuity between Head Up Display main switch harness connector and ground.

Head Up Display switch Ground Continuity
Connector Terminal
M109 8 Yes

YES>>

GO TO 3.

NO>>

Repair harness or connector.

CHECK HEAD UP DISPLAY SWITCH

Check Head Up Display switch. Refer to Component Inspection.

Is the inspection result normal?

YES>>

Replace Head Up Display unit. Refer to Removal and Installation.

NO>>

Replace Head Up Display main switch. Refer to Removal and Installation.

Component Inspection

CHECK HEAD UP DISPLAY SWITCH

  1. Ignition switch OFF.

  2. Remove Head Up Display switch. Refer to Removal and Installation.

  3. Check the continuity between Head Up Display switch terminals as per the following condition.

    Head Up Display switch Condition Continuity
    Terminal
    6 8 Press the Head Up Display switch Yes
    Other then above No

Is the inspection result normal?

YES>>

Inspection End.

NO>>

Replace Head Up Display switch. Refer to Removal and Installation.

    Oil Level Sensor Signal Circuit
    DiagnosisProcedure CHECK OIL LEVEL SENSOR CIRCUIT Ignition switch OFF. Disconnect combination meter harness connector and oil level sensor harness connector. Check continuity be...
    Type a. Symptom Diagnosis
    Head up Display Symptoms Symptom Table CAUTION: If display distortion occurs after replacing the Head Up Display unit, perform calibration using CONSULT. Refer to CONSULT Functi...

    Other materials:

    C10b3-44 Parking Brake Control Module
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition C10B3 44 Parking brake control module (Parking brake control module) Diagnosis condition When ignition switch is ON Signal (terminal) — Threshold ...

    Rear-facing child restraint installation using LATCH
    For additional information, refer to all Warnings and Cautions in the “Child safety” and “Child restraints” sections before installing a child restraint. Do not use the lower anchors if the combined weight of the child and the child restraint exceeds 65 lbs (29.5 kg). If the combined wei ...

    B120e-42 Ipdm E/r
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC detection condition B120E-42 IPDM E/R (Intelligent power distribution module engine room) [MEMORY ERROR] 1 Diagnosis condition When the power consumption control of IPDM E/R chan ...