Nissan Rogue (T33) 2021-Present Service Manual: Head Lamp

Nissan Rogue (T33) 2021-Present Service Manual / Electrical & Power Control :: Body Control System / System Description :: Diagnosis System (bcm) / Head Lamp

CONSULT Function (BCM - HEAD LAMP)

DATA MONITOR

NOTE:

The following table includes information (items) inapplicable to this Nissan Ariya vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items.

Monitor item

[Unit] 		Description

Door switch assist

[Off/On] 		Indicates [ON/OFF] condition of front door switch RH.

Door switch rear right

[Off/On] 		Indicates [On/OFF] condition of rear door switch RH.

Door switch rear left

[Off/On] 		Indicates [On/OFF] condition of rear door switch LH.

Door switch driver

[Off/On] 		Indicates [ON/OFF] condition of front door switch LH.

Optical sensor

[–] 		The value of outside brightness input from the optical sensor.
    Flasher
    CONSULT Function (BCM - FLASHER) DATA MONITORNOTE: The following table includes information (items) inapplicable to this Nissan Ariya vehicle. For information (items) applicable...
    Intelligent Key
    CONSULT Function (BCM - INTELLIGENT KEY) DATA MONITORNOTE: The following table includes information (items) inapplicable to this Nissan Ariya vehicle. For information (items) ap...

    Other materials:

    P0011 Ivt Control
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0011 00 INT/V TIM CONT-B1 (“A” Camshaft position - timing over-advanced or system performance bank 1) Diagnosis condition Engine running Signal (term ...

    Egr Volume Control Valve
    Component Inspection CHECK EGR VOLUME CONTROL VALVE-1 With CONSULT Ignition switch ON (engine stopped). Perform “EGR CONTROL VALVE” in “ACTIVE TEST” mode of “ENGINE” using CONSULT. Operate “Up” or “Down”, set “EGR VALVE POSITION” to 0 deg, and check value “ ...

    Symptom Diagnosis. Squeak and Rattle Trouble Diagnoses
    Work Flow CUSTOMER INTERVIEWInterview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diagnostic Worksheet during the interview to document the facts and conditions when the noise occurs and any customer comments. Refer to Diagnostic Worksheet ...