Nissan Rogue (T33) 2021-Present Service Manual: Fuel Tank Temperature Sensor

Component Inspection

CHECK FUEL TANK TEMPERATURE (FTT) SENSOR

  1. Turn ignition switch OFF.

  2. Disconnect fuel level sensor unit and fuel pump harness connector.

  3. Check the resistance between fuel level sensor unit and fuel pump terminals.

    Fuel level sensor unit and fuel pump Condition Resistance
    Terminal
    8 7 Temperature [°C (°F)] 20 (68) 2.3 – 2.7 kΩ
    50 (122) 0.79 – 0.90 kΩ

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Replace fuel level sensor unit and fuel pump. Refer to Exploded View.

    Fuel Rail Pressure Sensor
    Component Inspection CHECK FUEL RAIL PRESSURE (FRP) SENSOR With CONSULT Turn ignition switch OFF. Reconnect harness connector disconnected. Start engine and warm it up to normal...
    Heated Oxygen Sensor 2
    Component Function Check PERFORM COMPONENT FUNCTION CHECK-1 Without CONSULT Start engine and warm it up to normal operating temperature. Turn ignition switch OFF and wait at lea...

    Other materials:

    Removal and Installation. Front Coil Spring and Strut
    Exploded View Piston rod lock nut Mounting insulator Mounting bearing Bound bumper Upper rubber seat Coil spring Lower rubber seat Strut Steering knuckle : N·m (kg-m, ft-lb)         : Always replace after every di ...

    System
    Meter System System Description SYSTEM DIAGRAM Parts name Description Ambient sensor Refer to Ambient Sensor. BCM Transmits the BCM status to the combination meter via CAN communication. Combination meter Refer to Combination Meter. ECM Transmits the ECM status to ...

    U288c-88 Ethernet Circuit
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detected condition U288C-88 Ethernet circuit Diagnosis condition When ignition switch is ON. Signal (terminal) — Threshold Lost ethernet communication with combination meter and/or Head Up Display u ...