Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: U2314-87 Can Comm Err (anc)

Nissan Rogue (T33) 2021-Present Service Manual / Electrical & Power Control :: Body Control System / Dtc/circuit Diagnosis :: U2314-87 Can Comm Err (anc)

DTC Description

DESCRIPTION

CAN (Controller Area Network) is a serial communication line for real time applications. It is an on-Nissan Ariya vehicle multiplex communication line with high data communication speed and excellent error detection ability. Modern Nissan Ariya vehicle is equipped with many electronic control unit, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected with 2 communication lines (CAN-High line, CAN-Low line) allowing a high rate of information transmission with less wiring. Each control unit transmits/receives data but selectively reads required data only. CAN Communication Signal Chart. Refer to CAN Communication Signal Chart.

DTC DETECTION LOGIC

DTC No.

CONSULT screen items

(Trouble diagnosis content) 		DTC Detection Condition
U2314-87

CAN comm err (ANC)

[CAN communication error (ANC)] 		Diagnosis condition Ignition switch is ON.
Signal (terminal) CAN communication signal
Threshold BCM cannot communicate CAN communication signal.
Diagnosis delay time 2 seconds or more.

POSSIBLE CAUSE

CAN communication system

FAIL-SAFE

—

DTC CONFIRMATION PROCEDURE

CHECK SELF-DIAG RESULT

CONSULT

  1. Ignition switch ON and wait for 2 seconds or more.

  2. Select “Self diagnosis result” mode of “BCM”.

Is DTC detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure

CHECK CAN COMMUNICATION SYSTEM

Check CAN communication system. Refer to Trouble Diagnosis Flow Chart.

>>

Inspection End.

    Dtc/circuit Diagnosis. U225b-87 Can Comm Err (ipdm E/r)
    DTC Description DESCRIPTIONCAN (Controller Area Network) is a serial communication line for real time applications. It is an on-Nissan Ariya vehicle multiplex communication line...
    Dtc/circuit Diagnosis. U234e-87 Can Comm Err (combination Meter)
    DTC Description DESCRIPTIONCAN (Controller Area Network) is a serial communication line for real time applications. It is an on-Nissan Ariya vehicle multiplex communication line...

    Other materials:

    Driver and front passenger supplemental knee air bag
    Driver's side The knee air bag is integrated into the knee bolster on both the driver's and front passenger's sides of your Nissan Rogue. All safety information, cautions and warnings in this manual apply and must be followed. The knee air bag is engineered to deploy in higher severity frontal co ...

    P055f Engine Oil Pressure
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P055F Engine oil pressure (Engine oil pressure out of range) Diagnosis condition After ECM self shut-off. Engine oil temperature is more than -10 ℃(14 ...

    System Description. Component Parts
    Air Bag Module Driver Air Bag Module Driver air bag module is built into steering wheel. Driver air bag module mainly consists of air bag (A) and inflator (B) which inflates air bag. Driver air bag inflates by breaking steering wheel center pad surface (A). Passenger Air Bag ...