Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: U214f-87 Can Comm Err (bcm)

Nissan Rogue (T33) 2021-Present Service Manual / Brakes :: Brake System / Dtc/circuit Diagnosis :: U214f-87 Can Comm Err (bcm)

DTC Description

DTC DETECTION LOGIC

DTC No. CONSULT screen terms DTC detection condition
U214F 87 CAN communication error (BCM) 1 Diagnosis condition When Ignition switch is ON.
Signal (terminal) CAN communication signal
Threshold When not receiving from BCM.
Diagnosis delay time 2 seconds or more
2 Diagnosis condition When Ignition switch is ON.
Signal (terminal) CAN communication signal
Threshold When not transmitting to BCM.
Diagnosis delay time 2 seconds or more

POSSIBLE CAUSE

  • BCM

  • CAN communication line

FAIL-SAFE

Normal control

Confirmation Procedure

PRECONDITIONING

If “Confirmation Procedure” has been previously conducted, always Ignition switch OFF, get out of the Nissan Ariya vehicle, close all doors (other than hood assembly), check that the combination meter is OFF, and wait for 1 minute or more without opening these doors.

CAUTION:

Never operate the Nissan Ariya vehicle.

>>

GO TO 2.

CHECK DTC DETECTION

CONSULT

  1. Ignition switch OFF to ON without depressing the brake pedal.

  2. Ignition switch OFF and disconnect CONSULT from data link connector.

  3. Get out of the Nissan Ariya vehicle, close all doors (other than hood assembly), check that the combination meter is OFF, and wait for 1 minute or more without opening these doors.

    CAUTION:

    Never operate the Nissan Ariya vehicle.

  4. Ignition switch ON without depressing the brake pedal.

  5. Erase self-diagnosis result for “BRAKE”.

  6. Ignition switch OFF and disconnect CONSULT from data link connector.

  7. Get out of the Nissan Ariya vehicle, close all doors (other than hood assembly), check that the combination meter is OFF, and wait for 1 minute or more without opening these doors.

    CAUTION:

    Never operate the Nissan Ariya vehicle.

  8. Ignition switch ON without depressing the brake pedal.

  9. Perform self-diagnosis for “BRAKE”.

Is DTC “U214F-87" detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure

Refer to Trouble Diagnosis Flow Chart.

    Dtc/circuit Diagnosis. U2148-87 Can Comm Err (brake Control Unit)
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detection condition U2148 87 CAN communication error brake control unit 1 Diagnosis condition When Ignition ...
    Dtc/circuit Diagnosis. U2240-87 Can Comm Circuit
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detection condition U2240 87 Controller area network communication error (Engine control module) 1 Diagnosis...

    Other materials:

    C1203-86 Abs Signal
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detecting condition C1203-86 ABS SYSTEM (Antilock brake system) Diagnosis condition Ignition switch: ON Nissan Ariya Vehicle running Signal Wheel speed signals ...

    C107c-53 Not Configuration
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition C107C 53 Not configuration (Not configuration) Diagnosis condition When ignition switch is ON. When the power supply voltage is normal. Signa ...

    Symptom Diagnosis. Easy Fill Tire Alert Does Not Activate
    Description The easy fill tire alert does not function while inflating a tire when the CVT shift selector position is in P-range with the ignition switch ON or with the engine started.NOTE: After starting to inflate the tire, it takes a few seconds for the easy fill tire alert to function. ...