Nissan Rogue (T33) 2021-Present Service Manual: C1203-86 Abs Signal
DTC Description
DTC DETECTION LOGIC
| DTC |
CONSULT screen terms (Trouble diagnosis content) | DTC detecting condition | |
|---|---|---|---|
| C1203-86 |
ABS SYSTEM (Antilock brake system) |
Diagnosis condition |
|
| Signal | Wheel speed signals | ||
| Threshold | AWD control unit cannot receive the wheel speed signal. | ||
| Diagnosis delay time | 2 seconds or more | ||
POSSIBLE CAUSE
ABS malfunction (wheel speed signal error)
FAIL-SAFE
Although AWD control is canceled, the vehicle can drive at 2WD condition.
DTC CONFIRMATION PROCEDURE
PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE� has been previously conducted, always place ignition switch OFF and wait at least 10 seconds before conducting the next test.
>>
GO TO 2.
DTC REPRODUCTION PROCEDURE
CONSULT
-
Ignition switch ON.
-
Drive at 10 km/h (6 MPH) or more for approximately 5 minutes in urban areas.
-
Stop the Nissan Ariya vehicle.
-
Perform "Self diagnosis result" mode of “AWD/4WD�.
Is DTC “C1203-86� detected?
YES>>Proceed to diagnosis procedure. Refer to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: Inspection End.
DTC Diagnosis Procedure
PERFORM SELF DIAGNOSIS OF ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)
CONSULT
Perform "Self diagnosis result" mode of “ABS�.
Is any DTC detected?
YES>>Check the DTC. Refer to DTC Index.
NO>>GO TO 2.
CHECK TERMINALS AND HARNESS CONNECTORS
Check AWD control unit pin terminals for damage or loose connection with harness connector.
Is inspection result normal?
YES>>After placing the ignition switch OFF, perform DTC confirmation procedure again. If DTC “C1203–86� is detected, replace actuator assembly due to the malfunction of the AWD control unit. Refer to Disassembly and Assembly.
NO>>Repair or replace error-detected parts.
Other materials:
Moniteur de vue arrière (Caméra de recul)
Informations de sécurité
Bouton d'accès rapide CAMÉRA
AVERTISSEMENT CRUCIAL
La caméra de votre Nissan Rogue est une aide au stationnement, mais elle ne remplace en aucun cas la vigilance humaine. Vérifiez toujours physiquement votre environnement direct.
Les lignes ...
Laser Branch Line Circuit
Diagnosis Procedure
CHECK CONNECTOR
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side).
Distance sensor
Harness connector B2 ...
Adas Control Unit. Basic Inspection
Additional Service When Replacing Adas Control Unit 2
Without Propilot Assist 2.1
Work Procedure
Always perform the additional service after replacing the ADAS control unit 2.ADAS CONTROL UNIT 2 CONFIGURATION
Perform saving Nissan Ariya vehicle internal information according to "Replace ECU" i ...
