Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: P161e-00 Immobilizer
DTC Description
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen items (Trouble diagnosis content) | DTC detecting condition | |
|---|---|---|---|
| P161E-00 |
IMMOBILIZER (Immobilizer) |
Diagnosis condition | Ignition switch ON |
| Signal (terminal) | — | ||
| Threshold | When CONSULT is not used during ECM replacement. | ||
| Diagnosis delay time | 1 second or less | ||
POSSIBLE CAUSE
-
Intelligent Key unit
-
ECM
FAIL-SAFE
Inhibit engine cranking
CONFIRMATION PROCEDURE
DTC CONFIRMATION
CONSULT
-
Ignition switch ON.
-
Select “Self diagnosis result” mode of “ECM”.
Is the DTC detected?
YES>>Refer to DTC Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: Inspection End.
DTC Diagnosis Procedure
ECM REGISTRATION
CONSULT
Register ECM.
Is the DTC detected?
YES>>GO TO 2.
NO>>Inspection End.
REPLACE INTELLIGENT KEY UNIT
Replace Intelligent Key unit. Refer to Removal and Installation.
Is the DTC detected?
YES>>GO TO 3.
NO>>Inspection End.
REPLACE ECM
Replace ECM. Refer to ECM : Removal & Installation.
>>
Inspection End.
Other materials:
B3a70 Intelligent Battery Sensor
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
B3A70
00
IBS Battery Temp Sensor Failure (Open Circuit)
[IBS battery temp sensor failure (Open circuit)]
Diagnosis condition
Ignition switch ON
Batte ...
P2123 App Sensor
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P2123
00
APP SEN 1/CIRC
(Throttle/Pedal position sensor/switch D circuit high)
Diagnosis condition
Engine running at idle
Signal (terminal)
Accelerator ...
B120e-55 Ipdm E/r
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen items
(Trouble diagnosis content) DTC detection condition
B120E-55
IPDM E/R
(Intelligent power distribution module engine room)
[NOT CONFIGURED]
Diagnosis condition
When ignition switch is ON
Signal (terminal)
...
