Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: Hazard Function

Component Function Check

CHECK FUNCTION

CONSULT

  1. Select “Flasher” in “Active test” mode of "BCM".

  2. Touch “LH” or “RH” to check that it works normally.

Is the inspection result normal?

YES>>

Hazard warning lamp circuit is OK.

NO>>

Refer to Diagnosis Procedure.

Diagnosis Procedure

CHECK HAZARD OPERATION

Refer to System Description.

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Refer to Symptom Table.

CHECK INTERMITTENT INCIDENT

Refer to Intermittent Incident.

>>

Inspection End.

    Dtc/circuit Diagnosis. Door Switch
    Component Function Check CHECK FUNCTION CONSULT Select “Door switch driver”, “Door switch assist”, “Door switch rear left” and “Door switch rear right” in “Dat...
    Dtc/circuit Diagnosis. Intelligent Key Battery
    Component Inspection CHECK INTELLIGENT KEY BATTERY Check by connecting a resistance (approximately 300 Ω) so that the current value becomes about 10 mA. Refer to Removal and I...

    Other materials:

    P2564 Wastegate Control Valve Position Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P2564 00 TC BOOST CONTROL POSITN SEN A (Turbocharger boost control position sensor A circuit low) Diagnosis condition — Signal (terminal) — Threshol ...

    Symptom Diagnosis. Take Away Warning Does Not Operate
    Diagnosis Procedure CHECK COMBINATION METER BUZZER Check combination meter buzzer. Refer to Diagnosis Procedure (Full TFT meter) or Diagnosis Procedure (7 inch information display). Is the inspection result normal? YES>> GO TO 2. NO>> Repair or replace the malfunctioning parts. ...

    Removal and Installation. Front Pillar Finisher
    Exploded View Grommet Clip Front pillar finisher Rubber         : Nissan Ariya Vehicle front : Always replace after every disassembly. Removal and Installation REMOVALFully open front door. Remove fender cover. Refer to Removal and I ...