Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: Door Request Switch

Nissan Rogue (T33) 2021-Present Service Manual / Body Exterior, Doors, Roof & Vehicle Security :: Door & Lock / Dtc/circuit Diagnosis :: Door Request Switch

Component Inspection

CHECK DOOR REQUEST SWITCH

  1. Ignition switch OFF.

  2. Disconnect malfunctioning door request switch connector.

  3. Check continuity between malfunctioning door request switch terminals.

Door request switch Condition Continuity
Terminal
1 2 Door request switch Pressed Yes
Released No

Is the inspection result normal?

YES>>

Inspection End.

NO>>

Replace outside handle. Refer to Removal and Installation (front door) or Removal and Installation (rear door).

    Dtc/circuit Diagnosis. Door Lock/unlock Switch
    Front Lh Component Function Check CHECK FUNCTION CONSULT Ignition switch ON. Select “Door lock and unlock switch (lock)”, “Door lock and unlock switch (unlock)” in “Da...
    Dtc/circuit Diagnosis. Door Switch
    Component Function Check CHECK FUNCTION CONSULT Select “Door switch driver”, “Door switch assist”, “Door switch rear left” and “Door switch rear right” in “Dat...

    Other materials:

    Steering Assist
    Basic information Steering Assist is a part of the ProPILOT Assist Systems available on the Nissan Rogue. Read the entire ProPILOT Assist section before using this system, including how to operate it and how to understand the display information. Steering Assist uses a forward-facing camera to detec ...

    Mode OFF-ROAD (modèles à transmission intégrale)
    Le mode OFF-ROAD du Nissan Rogue à transmission intégrale facilite la conduite et le démarrage sur des surfaces difficiles, telles que des chemins de terre irréguliers, des routes fortement dégradées, des montées raides ou encore des terrains meubles comme le sable. Ce mode adapte automatique ...

    Writing of Calibration Data
    Work Procedure DESCRIPTIONIf only the around view monitor control unit is replaced, the calibration data stored in the camera can be written to the around view monitor control unit by selecting "Camera Calibration" of "Work Support" mode in CONSULT.WORK PROCEDUREWRITE CALIBRATION DATA With C ...