Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: C1621-86 Bcm System
DTC Description
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | |||
|---|---|---|---|---|---|
| C1621 | 86 |
BCM system (Body control module system) |
Diagnosis condition | When ignition switch is ON. | |
| Signal (terminal) | CAN communication signal | ||||
| Threshold | When a malfunction is detected in BCM. | ||||
| Diagnosis delay time | 2 seconds or more | ||||
POSSIBLE CAUSE
-
CAN communication line
-
BCM
-
Power steering control module
FAIL-SAFE
Normal state
DTC CONFIRMATION PROCEDURE
PRECONDITIONING
-
Pull the parking brake switch.
NOTE:
Check to make sure that the parking brake switch indicator is turned ON.
-
Ignition switch OFF.
-
Get out of the Nissan Ariya vehicle and close all doors.
-
Wait 65 seconds.
NOTE:
-
Check to make sure that the parking brake switch indicator is turned OFF.
-
If the rear brake calipers are hot, wait up to an hour until parking brake indicator light on the switch turns OFF. Once indicator light on the switch turns OFF, move to next step.
-
>>
GO TO 2.
DTC REPRODUCTION PROCEDURE
CONSULT
-
Ignition switch ON.
-
Perform self diagnosis for “EPS/Direct Adaptive Steering 3”.
Is DTC “C1621-86” detected?
YES>>Proceed to diagnosis procedure. Refer to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: Inspection End.
Diagnosis Procedure
PERFORM SELF-DIAGNOSIS
CONSULT
-
Ignition switch OFF to ON.
-
Perform self diagnosis for "BCM".
Is any DTC detected?
YES>>Check the DTC. Refer to DTC Index.
NO>>GO TO 2.
CHECK CONNECTOR AND TERMINAL
-
Ignition switch OFF.
-
Disconnect BCM harness connector.
-
Disconnect power steering control module harness connector.
-
Check the connector for disconnection or looseness.
-
Check the terminals for damage or loose connection with harness connector.
Is the inspection result normal?
YES>>GO TO 3.
NO>>Repair or replace harness, connector, or terminal, securely lock the connector.
PERFORM SELF-DIAGNOSIS
CONSULT
-
Connect BCM harness connector.
-
Connect power steering control module harness connector.
-
Ignition switch OFF to ON.
-
Erase self diagnosis results for “EPS/Direct Adaptive Steering 3”.
-
Pull the parking brake switch.
NOTE:
Check to make sure that the parking brake switch indicator is turned ON.
-
Ignition switch OFF.
-
Get out of the Nissan Ariya vehicle and close all doors.
-
Wait 65 seconds.
NOTE:
-
Check to make sure that the parking brake switch indicator is turned OFF.
-
If the rear brake calipers are hot, wait up to an hour until parking brake indicator light on the switch turns OFF. Once indicator light on the switch turns OFF, move to next step.
-
-
Ignition switch ON.
-
Perform self diagnosis for “EPS/Direct Adaptive Steering 3”.
Is DTC “C1621–86” detected?
YES>>Replace the power steering control module (steering gear assembly). Refer to Removal and Installation.
NO>>Inspection End.
Other materials:
Tcm
Reference Value
CONSULT DATA MONITOR STANDARD VALUE
In CONSULT, electric shift timing or lock-up timing, i.e. operation
timing of each solenoid valve, is displayed. Therefore, if there is an
obvious difference between the shift timing estimated from a shift shock
(or engine speed variation ...
Charge Air Cooler
Exploded View
Charge air cooler
Charge air cooler Bracket 1
Turbocharger boost sensor (with intake air temperature sensor 2)
O-ring
Electronic throttle control actuator gasket
Charge air cooler Bracket 2
Air inlet hose
To r ...
B20a4-87 Headlamp (lh) Lin Communication
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen items
(Trouble diagnosis content) DTC detection condition
B20A4–87
Headlamp (LH) LIN communication
[Headlamp (left hand) local interconnect network communication]
[MISSING MESSAGE]
Diagnosis condition
Ignition switch ...
