Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: B2f98-04 Sunshade Motor

DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content)
DTC detecting condition
B2F98-04

Sunshade motor

(Sunshade motor)
Diagnosis condition When ignition switch ON or timer operates.
Signal (terminal)
Threshold CPU in sunshade motor assembly detect internal malfunction
Diagnosis delay time 1 second or less

POSSIBLE CAUSE

Sunshade motor assembly

FAIL SAFE

Sunshade auto operation is forbidden

DTC CONFIRMATION PROCEDURE

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Ignition switch ON.

  2. Operate sunshade switch to any position.

  3. Select “Self diagnosis result” mode of “BCM”.

  4. Check DTC.

Is DTC detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure

REPLACE SUNSHADE MOTOR ASSEMBLY

Replace sunshade motor assembly. Refer to Removal and Installation.

YES>>

Inspection End.

    Basic Inspection. Anti-Pinch Inspection
    Description Check anti-pinch function when the initialization of moonroof and sunshade system is performed. Refer to Work Procedure. Work Procedure CHECK ANTI-PINCH FUNCTION Ful...
    Dtc/circuit Diagnosis. Power Supply and Ground Circuit
    Moonroof Motor Assembly Diagnosis Procedure CHECK FUSE Ignition switch OFF. Check that the following fuse is not blown (open): Fuse No. Capacity 31 15 A Is the fuse blown (open)...

    Other materials:

    Liquide de frein
    Pour des informations détaillées concernant le type, la capacité et les spécifications du liquide de frein, reportez-vous à la section « Contenances et liquides/lubrifiants recommandés » de ce manuel du Nissan Rogue. AVERTISSEMENT Utilisez uniquement du liquide de frein neuf provenant ...

    Removal and Installation. Rear Deflector
    Exploded View Screw grommet Rear deflector     : Nissan Ariya Vehicle front Removal and Installation REMOVALRemove rear deflector fixing screws and clip, and then remove rear deflector.INSTALLATIONInstallation is in the reverse order of removal. ...

    Illumination Control Switch Signal Circuit
    Component Function Check CHECK COMBINATION METER INPUT SIGNAL Ignition switch ON. Measure voltage between the following terminals of the combination meter. Combination meter Condition Voltage (Approx.) Connector Terminals (+) (−) M73 (U.S.A. production) ...