Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: B2cb4-49 Rain Sensor
DTC Description
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | |
|---|---|---|---|
| B2CB4–49 |
Rain sensor (Rain sensor) |
Diagnosis condition | Ignition switch is ON. |
| Signal (terminal) | — | ||
| Threshold | Rain and light sensor internal malfunction. | ||
| Diagnosis delay time | 2 seconds or more | ||
POSSIBLE CAUSE
Rain and light sensor
FAIL SAFE
-
Turns ON the headlamp (low)
-
Turns OFF high beam assist
-
Turns OFF rain sensing front wipers
DTC CONFIRMATION PROCEDURE
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
-
Ignition switch ON.
-
Select “Self diagnosis result” mode of “BCM”.
-
Check DTC.
Is DTC detected?
YES>>Refer to DTC Diagnosis Procedure.
NO>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO>>Confirmation after repair: Inspection End.
DTC Diagnosis Procedure
REPLACE RAIN AND LIGHT SENSOR
Replace rain and light sensor. Refer to Removal and Installation.
>>
Inspection End.
Other materials:
Ssg Branch Line Circuit
Diagnosis Procedure
CHECK CONNECTOR
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the sub starter & generator
for damage, bend and loose connection (unit side and connector side).
Is the inspect ...
Détection des mains
Informations de base
Lorsque la direction assistée est activée sur le Nissan Rogue, le véhicule surveille en permanence les mouvements et la prise du volant à l’aide de capteurs capacitifs et de couple intégrés directement dans le volant. Lorsque ProPILOT Assist s’affiche en mode « Mains ...
Chassis control
Basic information
The chassis control system in the Nissan Rogue uses an electric control module that manages the following functions:
Intelligent Trace Control
Active Ride Control (if so equipped)
Intelligent Trace Control
This feature analyzes the driver’s steering, acceleration and braking ...