Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: B2906-31 Recliner Sensor

Nissan Rogue (T33) 2021-Present Service Manual / Body Interior :: Automatic Drive Positioner / Dtc/circuit Diagnosis :: B2906-31 Recliner Sensor

DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen items

(Trouble diagnosis content) 		DTC detection condition
B2906-31 Recliner Sensor Diagnosis condition When the ignition switch is ON.
Signal (terminal) Reclining Motor (terminal #5)
Threshold Sensor signal not received
Diagnosis delay time 100 mili- seconds or more

POSSIBLE CAUSE

  • LH reclining motor

  • Driver seat control unit

  • Harness and connectors

FAIL-SAFE

Stop automatic drive position function.

DTC CONFIRMATION PROCEDURE

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Ignition switch ON and wait for 20 seconds or more.

  2. Check “Self diagnosis result” mode of “DRIVER SEAT”.

Is DTC detected?

YES>>

Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: Inspection End.

Diagnosis Procedure

CHECK RECLINING MOTOR SENSOR SIGNAL

  1. Ignition switch OFF.

  2. Disconnect driver seat control unit and LH reclining motor.

  3. Check continuity between driver seat control unit harness connector and LH reclining motor harness connector.

Driver seat control unit LH reclining motor Continuity
Connector Terminal Connector Terminal
B213 36 B217 5 Yes

Is the inspection result normal?

YES>>

Connect driver seat control unit and LH reclining motor. Component Function Check

NO>>

Repair the harness or connector.

    Dtc/circuit Diagnosis. B2906-12 Recliner Sensor
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC detection condition B2906-12 Recliner Sensor Diagnosis condition When the igniti...
    Dtc/circuit Diagnosis. B2907-11 Lift Sensor
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC detection condition B2907-11 Lift Sensor Diagnosis condition The Lift Sensor sig...

    Other materials:

    2wd. Preparation. Preparation
    Preparation Special Service Tool Tool number (TechMate No.) Tool name Description KV40104000 ( – ) Hub lock nut wrench a: 85 mm (3.35 in) b: 65 mm (2.56 in) Removing and Installing wheel hub lock nut. KV40107300 ( – ) Boot band crimping tool Installing bo ...

    Dtc/circuit Diagnosis. B242a-98 Closure Motor
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition B242A-98 Closure motor (Closure motor) Diagnosis condition When back door closure function operate Signal (terminal) — Threshold When thermal prot ...

    Information Display (combination Meter)
    Door Open Warning DESIGN/PURPOSEInformation display warns the driver that each door is open or is not fully closed. Symbol Message – SYNCHRONIZATION WITH MASTER WARNING LAMPSynchronization is applied.Refer to Master Warning Lamp.SYSTEM DIAGRAMSIGNAL PATH BCM transmits door switch ...