Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: B2907-11 Lift Sensor
DTC Description
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen items (Trouble diagnosis content) | DTC detection condition | |
|---|---|---|---|
| B2907-11 | Lift Sensor | Diagnosis condition | The Lift Sensor signal is shorted to ground |
| Signal (terminal) | Lifting Motor (terminal #5) | ||
| Threshold | 0.00 - 0.352 V | ||
| Diagnosis delay time | 100 mili- seconds or more | ||
POSSIBLE CAUSE
-
LH Lifting Motor
-
Driver seat control unit
-
Harness or connectors
FAIL-SAFE
—
DTC CONFIRMATION PROCEDURE
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
-
Ignition switch ON and wait for 20 seconds or more.
-
Check “Self diagnosis result” mode of “DRIVER SEAT”.
Is DTC detected?
YES>>Refer to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: Inspection End.
Diagnosis Procedure
CHECK LIFTING MOTOR SENSOR SIGNAL
-
Ignition switch OFF.
-
Disconnect driver seat control unit and LH lifting motor.
-
Check continuity between driver seat control unit harness connector and ground.
| (+) | (-) | Continuity | |
|---|---|---|---|
| Driver seat control unit | |||
| Connector | Terminal | ||
| B213 | 16 | Ground | Yes |
Is the inspection result normal?
YES>>Connect driver seat control unit and LH lifting motor. Refer to Component Function Check
NO>>Repair the harness or connector.
Other materials:
C106e-54 Steering Angle Sensor
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
C106E
54
Steering angle sensor
(Steering angle sensor)
Diagnosis condition
When ignition switch is ON.
When the power supply voltage is normal.
...
C1f59-04 Eps Circuit
Without Propilot Assist 2.1
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
C1F59
04
EPS control unit
(Electric power steering control unit)
Diagnosis condition
When engine is running
Signal (termi ...
U2a8c-88 Ethernet Circuit
DTC Description
DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detected condition
U2A8C-88
Ethernet circuit
Diagnosis condition
When ignition switch is ON.
Signal (terminal)
—
Threshold
Lost ethernet communication with AV control unit
Diagnosis delay time ...
