Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: B2046-42 Eeprom

DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen items

(Trouble diagnosis content)
DTC Detection Condition
B2046-42

EEPROM

(Electrically Erasable Programmable Read-Only Memory)
Diagnosis condition Ignition switch ON
Signal (terminal)
Threshold EEPROM in Intelligent Key unit is malfunctioning
Diagnosis delay time 1 second or less

POSSIBLE CAUSE

  • Intelligent Key unit

  • Mistook the "Re programming"

FAIL-SAFE

DTC CONFIRMATION PROCEDURE

DTC CONFIRMATION

CONSULT

  1. Erase DTC.

  2. Ignition switch OFF.

  3. Ignition switch ON.

  4. Select “Self diagnosis result” mode of “INTELLIGENT KEY”.

Is DTC detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO–1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO–2>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure

PERFORM "ECU REPROGRAMMING"

CONSULT

  1. Select “ECU Reprogramming” mode of “INTELLIGENT KEY”.

  2. Erase DTC.

  3. Ignition switch OFF.

  4. Ignition switch ON.

  5. Select “Self diagnosis result” mode of “INTELLIGENT KEY”.

Is DTC detected?

YES>>

GO TO 2.

NO>>

Inspection End.

REPLACE INTELLIGENT KEY UNIT

Replace Intelligent Key unit. Refer to Removal and Installation.

>>

Inspection End.

    Dtc/circuit Diagnosis. B203d-14 Inside Antenna
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC detecting condition B203D-14 Inside antenna (Inside antenna) Diagnosis condition...
    Dtc/circuit Diagnosis. B2081-23 Request Sw (fl)
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition B2081-23 Request SW (FL) [Request switch (front left side)] ...

    Other materials:

    P0a1e Sub Starter & Generator
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0A1E 00 Starter/generator control module (Starter/generator control module) Diagnosis condition Engine running at idle Signal (terminal) CAN communica ...

    Comment activer/désactiver la fonction de maintien de frein automatique
    Comment activer la fonction de maintien de frein automatique 1. Lorsque le contact d’allumage du Nissan Rogue est placé sur la position ON, appuyez sur la commande de maintien de frein automatique 1. Le témoin lumineux de la commande de maintien de frein automatique 2 s’allume pour co ...

    Frein de stationnement
    Informations de base AVERTISSEMENT Ne conduisez jamais le Nissan Rogue lorsque le frein de stationnement est serré. Le système de freinage pourrait surchauffer et perdre en efficacité, ce qui pourrait entraîner un accident. Ne desserrez jamais le frein de stationnement depuis l’extérie ...