Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: B12b5-97 Frontal Collision
DTC Description
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen items (Trouble diagnosis content) | DTC Detection Condition | |
|---|---|---|---|
| B12B5-97 |
Frontal collision (Frontal collision) |
Diagnosis condition | When ignition switch is ON. |
| Signal (terminal) | Collision signal | ||
| Threshold | Frontal collision detected | ||
| Diagnosis delay time | 2 seconds or more. | ||
POSSIBLE CAUSE
Frontal collision
FAIL-SAFE
—
DTC CONFIRMATION PROCEDURE
CHECK SELF DIAGNOSIS RESULT
CONSULT
-
Ignition switch ON.
-
Perform “Self diagnosis result” mode of “AIR BAG” using CONSULT.
Is malfunctioning part detected?
YES>>Refer to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: Inspection End
Diagnosis Procedure
WARNING:
-
Before servicing, ignition switch OFF, disconnect battery negative terminal, and wait at least 3 minutes or more. (To discharge backup capacitor.)
-
Never use unspecified tester or other measuring device.
PERFORM COLLISION DIAGNOSIS
Perform collision diagnosis. Refer to When SRS is activated in a collision or When SRS is not activated in a collision.
>>
GO TO 2.
REPLACE AIR BAG DIAGNOSIS SENSOR UNIT
When DTC B12B5-97 is detected, replace air bag diagnosis sensor unit.
>>
Replace air bag diagnosis sensor unit. Refer to Removal and Installation.
Other materials:
Removal and Installation. Door Sash Cover
Exploded View
Front door panel
Front door sash cover front
Front door sash cover rear
Rear door sash cover front
Rear door sash cover rear
Rear door panel
Double-sided tape
[t: 1.2 mm (0.047 in)]
Double-sided tape
[t: 0.8 mm (0.031 in)]
Double-sid ...
Rear Automatic Braking (RAB)
Basic information
WARNING
Failure to observe the warnings and
instructions for proper RAB system use
could result in serious injury or death.
The RAB system is only a supplemental
aid for the driver. It does not replace
proper driving techniques.
Always use your side and rear mirrors, and
l ...
Garage mode system
The liftgate can be set to open to a specific
height by performing the following:
1. Open the liftgate.
2. Pull the liftgate down to the desired
position and hold the liftgate (the liftgate will have some resistance when
being manually adjusted).
3. While holding the liftgate in position,
press an ...
