Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: B0096-12 Door Satel Sens Rh
DTC Description
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen items (Trouble diagnosis content) | DTC Detection Condition | |
|---|---|---|---|
| B0096-12 |
DOOR SATEL SENS RH (Right Side Restraints Sensor 1) |
Diagnosis condition | When ignition switch is ON. |
| Signal (terminal) | Front door satellite sensor RH signal | ||
| Threshold | Front door satellite sensor RH circuit is shorted to power supply circuit. | ||
| Diagnosis delay time | 2 seconds or more. | ||
POSSIBLE CAUSE
-
Connection malfunction or short circuit to power supply of harness and connector
-
Internal malfunction of front door satellite sensor RH
-
Internal malfunction of air bag diagnosis sensor unit
FAIL-SAFE
—
DTC CONFIRMATION PROCEDURE
CHECK SELF DIAGNOSIS RESULT
CONSULT
-
Ignition switch ON.
-
Perform “Self diagnosis result” mode of “AIR BAG” using CONSULT.
Is malfunctioning part detected?
YES>>Refer to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: Inspection End
Diagnosis Procedure
WARNING:
-
Before servicing, ignition switch OFF, disconnect battery negative terminal, and wait at least 3 minutes or more. (To discharge backup capacitor.)
-
Never use unspecified tester or other measuring device.
CHECK HARNESS CONNECTOR
Check the harness connector.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Replace harness connector.
CHECK WIRING HARNESS
Check the wiring harness externals.
Is the inspection result normal?
YES>>GO TO 3.
NO>>Replace wiring harness.
REPLACE FRONT DOOR SATELLITE SENSOR RH
-
Replace front door satellite sensor RH. Refer to Removal and Installation.
-
Perform DTC confirmation procedure. Refer to DTC Description.
Is DTC detected?
YES>>GO TO 4.
NO>>Inspection End
REPLACE AIR BAG DIAGNOSIS SENSOR UNIT
-
Replace air bag diagnosis sensor unit. Refer to Removal and Installation.
-
Perform DTC confirmation procedure. Refer to DTC Description.
Is DTC detected?
YES>>GO TO 1.
NO>>Inspection End
Other materials:
Steering Switch Signal B Circuit
Component Function Check
CHECK COMBINATION METER INPUT SIGNAL
CONSULT
Ignition switch ON.
Select “Steering switch input” in “Data monitor” mode of “M&A”.
Check that the function operates normally according to the following conditions:
Condition Value
CONTRO ...
C10b1-01 Parking Brake Actuator (lh)
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
C10B1
01
Parking brake actuator (LH)
[Parking brake actuator (left)]
Diagnosis condition
When parking brake is apply or release
Signal (terminal)
—
...
Service Data and Specifications (sds)
General Specifications
BRAKE SYSTEMJAPAN PRODUCTION MODELS WITHOUT ProPILOT Assist 2.1Unit: mm (in) Front brake
Cylinder bore diameter
60.33 (2.3752)
Pad length × width × thickness
123.6 × 53.5 × 10.5 (4.87 × 2.106 × 0.413)
Rotor outer diameter × thickness
296 × 26.0 ( ...
