Nissan Rogue manuals

Nissan Rogue Service Manual: C1170 variant coding

DTC Logic

DTC DETECTION LOGIC

DTC Display Item Malfunction detected condition Possible causes
C1170 VARIANT CODING When the information in ABS actuator and electric unit (control unit) is not the same. ABS actuator and electric unit (control unit)

DTC CONFIRMATION PROCEDURE

1.CHECK SELF-DIAGNOSTIC RESULT

With CONSULT.

  1.  Turn ignition switch ON.
  2.  Perform self-diagnostic result.

Is DTC C1170 detected? YES >> Proceed to diagnosis procedure. Refer to BRC-104, "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

1.REPLACE ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)

Replace ABS actuator and electric unit (control unit) even if other DTCs are displayed with “VARIANT CODING” in self diagnostic result.

>> Replace ABS actuator and electric unit (control unit). Refer to BRC-136, "Removal and Installation".

C1164, C1165 CV system
DTC Logic DTC Logic DTC Display Item Malfunction detected condition Possible causes C1164 CV 1 When a malfunction is detected in cut valve 1. Harness or co ...

C1197 vacuum sensor
DTC Logic DTC DETECTION LOGIC DTC Display Item Malfunction detected condition Possible causes C1197 VACUUM SENSOR When a malfunction is detected in vacuum sensor. ...

Other materials:

Air flow charts
The following charts show the button and dial positions for MAXIMUM AND QUICK heating, cooling or defrosting. The air recirculation indicator should always be in the OFF position for heating and defrosting. ...

General maintenance
During the normal day-to-day operation of the vehicle, general maintenance should be performed regularly as prescribed in this section. If you detect any unusual sounds, vibrations or smells, be sure to check for the cause or have a NISSAN dealer do it promptly. In addition, you should notify ...

P1574 ASCD vehicle speed sensor
Description The ECM receives two vehicle speed sensor signals via CAN communication line. One is sent from combination meter, and the other is from TCM (Transmission control module). The ECM uses these signals for ASCD control. Refer to EC-47, "AUTOMATIC SPEED CONTROL DEVICE (ASCD) : Sys ...

© 2014-2025 Copyright www.nirogue.com