Nissan Rogue (T33) 2021-Present Service Manual: C10b3-55 Parking Brake Control Module

DTC Description

DTC DETECTION LOGIC

POSSIBLE CAUSE

NOTE:

Confirm if DTC is PAST or CRNT. If DTC is CRNT, proceed with Diagnosis Procedure. If DTC is PAST, clear DTC. Do not replace the ABS actuator and electric unit (control unit) for a PAST DTC.

FAIL-SAFE

The following functions are suspended.

Electric parking brake function

DTC CONFIRMATION PROCEDURE

PRECONDITIONING

If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always ignition switch OFF (Auto ACC function OFF) before conducting the next test.

GO TO 2.

CHECK DTC DETECTION

CONSULT

1. Ignition switch OFF (Auto ACC function OFF) to ON.

2. Push the parking brake switch.

   CAUTION:

   • Set the electric shift selector in the P position.

   • Depress the brake pedal.

3. Pull the parking brake switch.

4. Perform self-diagnosis for “ABS”.

Is DTC “C10B3-55” detected?

“CRNT” is displayed: Refer to Diagnosis Procedure.

“PAST” is displayed: Inspection End (Erase the memory of self-diagnosis results.)

To check malfunction symptom before repair: Refer to Intermittent Incident.

Confirmation after repair: Inspection End

Diagnosis Procedure

PROGRAMING OF ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)

Perform programing of ABS actuator and electric unit (control unit). Refer to Work Procedure.

GO TO 2.

PERFORM SELF-DIAGNOSIS

CONSULT

1. Ignition switch ON.

   CAUTION:

   Be sure wait of 10 seconds after ignition switch ON.

2. Perform self-diagnosis for “ABS”.

Is DTC “C10B3-55” detected?

"CRNT" is displayed: Replace the ABS actuator and electric unit (control unit). Refer to Removal and Installation.

“PAST” is displayed: Inspection End (Erase the memory of self-diagnosis results.)

Inspection End