Nissan Rogue (T33) 2021-Present Service Manual: C10b1-09 Parking Brake Actuator (lh)

Nissan Rogue (T33) 2021-Present Service Manual / Brakes :: Brake Control System / With Vdc :: Dtc/circuit Diagnosis / C10b1-09 Parking Brake Actuator (lh)

DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
C10B1 09

Parking brake actuator (LH)

[Parking brake actuator (left)] 		Diagnosis condition When parking brake is apply
Signal (terminal) —
Threshold When a motor of the parking brake actuator (LH) is not rotate.
Diagnosis delay time 10 seconds or more

POSSIBLE CAUSE

NOTE:

Confirm if DTC is PAST or CRNT. If DTC is CRNT, proceed with Diagnosis Procedure. If DTC is PAST, clear DTC. Do not replace the ABS actuator and electric unit (control unit) for a PAST DTC.

PAST DTC CRNT DTC

  • Harness or connector

  • Parking brake actuator (LH)

  • Rear brake caliper assembly (LH)

  • Fuse

  • Fusible link

  • 12V battery

  • Harness or connector

  • Parking brake actuator (LH)

  • Rear brake caliper assembly (LH)

  • ABS actuator and electric unit (control unit)

  • Fuse

  • Fusible link

  • 12V battery

FAIL-SAFE

The following functions are suspended.

Electric parking brake function

DTC CONFIRMATION PROCEDURE

PRECONDITIONING

If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always ignition switch OFF (Auto ACC function OFF) before conducting the next test.

>>

GO TO 2.

CHECK DTC DETECTION

CONSULT

  1. Ignition switch OFF (Auto ACC function OFF) to ON.

  2. Push the parking brake switch.

    CAUTION:

    • Set the electric shift selector in the P position.

    • Depress the brake pedal.

  3. Pull the parking brake switch.

  4. Perform self-diagnosis for “ABS”.

Is DTC “C10B1–09” detected?

YES-1>>

“CRNT” is displayed: Refer to Diagnosis Procedure.

YES-2>>

“PAST” is displayed: Inspection End (Erase the memory of self-diagnosis results.)

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: Inspection End

Diagnosis Procedure

CHECK CONNECTOR

  1. Disconnect 12V battery negative terminal.

  2. Check the parking brake actuator (LH) harness connector for disconnection or looseness.

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair / replace harness or connector. GO TO 2.

CHECK PARKING BRAKE ACTUATOR CIRCUIT (1)

  1. Disconnect the ABS actuator and electric unit (control unit) harness connector.

  2. Check the continuity between ABS actuator and electric unit (control unit) harness connector terminals.

    ABS actuator and electric unit (control unit) Continuity
    Connector Terminal
    E125 13 – 12 Existed

Is the inspection result normal?

YES>>

GO TO 4.

NO>>

GO TO 3.

CHECK PARKING BRAKE ACTUATOR CIRCUIT (2)

Check the continuity between parking brake actuator (LH) harness connector terminals.

Terminal Continuity
 
1 – 2 Existed
 

Is the inspection result normal?

YES>>

Repair/replace harness or connector.

NO>>

Replace the rear brake caliper assembly (LH). Refer to Removal and Installation.

CHECK TERMINAL

  1. Check parking brake actuator (LH) terminals for damage or loose connection with harness connector.

  2. Check ABS actuator and electric unit (control unit) terminals for damage or loose connection with harness connector.

the inspection result normal?

YES>>

GO TO 5.

NO>>

Repair/replace harness, connector or terminal. GO TO 5.

CHECK PARKING BRAKE ACTUATOR

  1. Connect the parking brake actuator (LH) harness connector.

  2. Connect the ABS actuator and electric unit (control unit) harness connector.

  3. Connect 12V battery negative terminal.

  4. Pull or push parking brake switch, and check the operation sound of parking brake actuator.

Is the inspection result normal?

YES>>

GO TO 6.

NO>>

Replace the parking brake actuator. Refer to Removal and Installation.

PERFORM SELF-DIAGNOSIS

CONSULT

  1. Ignition switch ON.

  2. Perform self-diagnosis for “ABS”.

Is DTC “C10B1-09” detected?

YES-1>>

"CRNT" is displayed: Replace the ABS actuator and electric unit (control unit). Refer to Removal and Installation.

YES-2>>

“PAST” is displayed: Inspection End (Erase the memory of self-diagnosis results.)

NO>>

Inspection End

    C10b1-01 Parking Brake Actuator (lh)
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition C10B1 01 Parking brake actuator (LH) [Parking brake actuator...
    C10b2-01 Parking Brake Switch
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition C10B2 01 Parking brake switch (Parking brake switch) Diagnos...

    Other materials:

    C106e-54 Steering Angle Sensor
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition C106E 54 Steering angle sensor (Steering angle sensor) Diagnosis condition When ignition switch is ON. When the power supply voltage is normal. ...

    P14a5 Charge Air Cooler Cooling Electric Water Pump
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P14A5 Charge air cooler coolant pump (Charge air cooler coolant pump control circuit high) Diagnosis condition Engine running at idle Warm-up condition ...

    Automatic air conditioner (models without rear control)
    Models with heated steering wheel Models without heated steering wheel Basic information Temperature control dial (driver's side) AUTO button Display screen SYNC button Temperature control dial (passenger's side) ON·OFF button Air recirculation button Fan speed buttons Air flow ...